MIKROE-957 mikroElektronika, MIKROE-957 Datasheet - Page 12

• Manufacturer Part Number: MIKROE-957
• Description: Other Development Tools ASLK PRO ANALOG DEVELOPMENT SYSTEM
• Manufacturer: mikroElektronika

Specifications of MIKROE-957

• Rohs: yes
• Product: Analog System Lab Kit PRO
• Tool Is For Evaluation Of: TL082, MPY634
• Operating Supply Voltage: 2.5 V to 5.5 V
• Description/function: Analog Lab Kit for Undergraduate Engineering
• Maximum Operating Temperature: + 125 C
• Minimum Operating Temperature: - 40 C

Lab Setup
The setup for the Analog System Lab is very simple and requires the following.
page 12
1
2
3
4
5
ASLK PRO and the associated Lab Manual from Texas Instruments India - the
lab kit comes with required connectors. Refer to Chapter 1.4 for an overview of
the kit.
Oscilloscope. We provide an experiment that helps you build a circuit to directly
interface analog outputs to an oscilloscope (See Chapter C).
Dual power supply with the operating voltages of ±10V.
Function generators which can operate in the range on 1 to 10 MHz and capable
of generating sine, square and triangular waves.
A computer with installed circuit simulation software.
In all the experiments of Analog System Lab, please note the following.
1
2
3
4
When we do not explicitly mention the magnitude and frequency of the input
waveform, please use 0 to 1V as the amplitude of the input and 1 kHz as the
frequency.
Always use sinusoidal input when you plot the frequency response and use
square wave input when you plot the transient response.
Precaution! Please note that TL082 is a dual OP-Amp. This means that the IC
has two OP-Amp circuits. If your experiment requires only one of the two ICs, do
not leave the inputs and output of the other OP- Amp open; instead, place the
second OP-Amp in unity-gain mode and ground the inputs.
Advisory to Students and Instructors. We strongly advise that the student
performs the simulation experiments outside the lab hours. The student must
bring a copy of the simulation results to the class and show it to the instructor at
the beginning of the class. The lab hours must be utilized only for the hardware
experiment and comparing the actual outputs with simulation results.
Analog System Lab Kit PRO