UMFT231XE-01 FTDI, UMFT231XE-01 Datasheet - Page 11

• Manufacturer Part Number: UMFT231XE-01
• Description: Interface Development Tools USB to UART DIP Dev. Module
• Manufacturer: FTDI
• Type: USB to UARTr
• Series: FT231Xr

Specifications of UMFT231XE-01

• Rohs: yes
• Product: Development Modules
• Tool Is For Evaluation Of: FT231XQ
• Interface Type: I2C, UART, USB
• Operating Supply Voltage: 3.3 V
• Description/function: USB to UART evaluation module
• Dimensions: 29.02 mm x 19.24 mm x 9.2 mm
• Operating Supply Current: 1 A
• Factory Pack Quantity: 25
• For Use With: FT231XQ

5.5
Figure 5.4 – USB Bus Powered 3.3V Logic Drive
The FT231X can process signals at CMOS/TTL logic levels in the range of 1.8V to 3.3V. This section
describes how to utilise this feature.
Figure 5.4 shows a configuration where the FT231X is interfaced to a device with IOs operating in the
range of 1.8V - 3.3V. The IO ports of this module need to be powered with a voltage level that is equal to
the level of the signals it is processing. Since the FT231X‟s embedded voltage regulator only outputs 3V3
the IO ports will need to be powered from another power source when operating at voltage levels other
than 3.3V.
By default, a short is present between 3V3OUT (embedded voltage regulator) and VCCIO (IO port‟s
power input with the connection made by JP1. If an external power supply is used to power the IO ports
this jumper needs to be open.
The configuration described in this section can be implemented in either bus-powered mode or self-
powered mode.
Note 1: The CBUS and DBUS pins are 5V tolerant; however these signals cannot drive signals at 5V
TTL/CMOS. VCCIO is not 5V tolerant; applying 5V to VCCIO will damage the chip.
Note 2: If power is applied to VCCIO and no power is applied to VCC all IOs will be at an unknown state,
this however will not damage the chip. The FT231X also has protective circuitry to prevent the chip being
damaged by a voltage discrepancy between VCCIO and the level of the signal being processed.
Note 3: When using VCCIO less than 3V3 on a chip from FTDI‟s X-chip range, it is recommended to use
pull up resistors (47K) to VCCIO on the data lines, all of the UMFT2xxXE devices include an on-board
pull-up for these lines.
Variable IO Voltage Supply
Vcc = 1.8V – 3.3V
MCU
TXD
RXD
RTS#
CTS#
Copyright © 2012 Future Technology Devices International Limited
Jumper JP1 - Open
GND
Document Reference No.: FT_000652
RXD
TXD
RTS#
CTS#
3V3OUT
VCCIO
VBUS
VCC
Clearance No.: FTDI#
Jumper JP2 - Closed
11
UMFT231XE
Version 1.0
GND
294