ADM00419 Microchip Technology, ADM00419 Datasheet - Page 13

• Manufacturer Part Number: ADM00419
• Description: Power Management IC Development Tools MCP2210 Breakout Module
• Manufacturer: Microchip Technology
• Type: Other Power Managementr

Specifications of ADM00419

• Rohs: yes
• Product: Evaluation Kits
• Tool Is For Evaluation Of: MCP2210
• Input Voltage: 3.3 V, 5 V

FIGURE 2-1:
© 2012 Microchip Technology Inc.
HEX/Decimal
user data
mode
SPI Transfer
Parameters
Section
SPI user data
section
SPI TERMINAL UTILITY WINDOW
After the application is started, the state of the connection with the MCP2210 is shown
in the Status Messages bar (in the lower left corner of the screen).
The user can establish the GP configuration. The GPs can be used as chip select pins.
Each GP Active and Idle value can be established by selecting the appropriate check-
boxes, or by directly supplying the correct value in the GP Direct Settings section. The
same behavior applies to the GP designation (the GP designation can be established
by clicking the appropriate radio-button, or by directly supplying the GP designation
value in the GP settings Direct Values section).
The SPI settings pertaining to the needed SPI transfer can be established in the SPI
Parameters section.
The data to be sent out is filled in the Tx Data field. To send the data to the SPI slave
device, press the SPI Transfer Data button on the lower right area of the screen. The
data received from the SPI slave device is displayed in the Rx Data field.
The user data can be supplied in either HEX or Decimal mode. This can be
accomplished by selecting the HEX mode checkbox. The data in the Tx and Rx Data
fields will be displayed in HEX or Decimal.
Status messages
Installation and Operation
GP Settings Section
Transfer Data button
GP Direct
Settings section
DS52057A-page 13