AT45DB161B-CNI Atmel, AT45DB161B-CNI Datasheet - Page 9

• Manufacturer Part Number: AT45DB161B-CNI
• Description: IC FLASH 16MBIT 20MHZ 8CASON
• Manufacturer: Atmel

Specifications of AT45DB161B-CNI

• Format - Memory: FLASH
• Memory Type: DataFLASH
• Memory Size: 16M (4096 pages x 528 bytes)
• Speed: 20MHz
• Interface: SPI, 3-Wire Serial
• Voltage - Supply: 2.7 V ~ 3.6 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 8-CASON
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: AT45DB161-CNI; AT45DB161-CNI

Power-on/Reset State
2224I–DFLSH–10/04
WRITE PROTECT: If the WP pin is held low, the first 256 pages of the main memory
cannot be reprogrammed. The only way to reprogram the first 256 pages is to first drive
the protect pin high and then use the program commands previously mentioned. If this
pin and feature are not utilized it is recommended that the WP pin be driven high
externally.
RESET: A low state on the reset pin (RESET) will terminate the operation in progress
and reset the internal state machine to an idle state. The device will remain in the reset
condition as long as a low level is present on the RESET pin. Normal operation can
resume once the RESET pin is brought back to a high level.
The device incorporates an internal power-on reset circuit, so there are no restrictions
on the RESET pin during power-on sequences. If this pin and feature are not utilized it is
recommended that the RESET pin be driven high externally.
READY/BUSY: This open drain output pin will be driven low when the device is busy in
an internally self-timed operation. This pin, which is normally in a high state (through
a 1 k external pull-up resistor), will be pulled low during programming operations, com-
pare operations, and during page-to-buffer transfers.
The busy status indicates that the Flash memory array and one of the buffers cannot be
accessed; read and write operations to the other buffer can still be performed.
When power is first applied to the device, or when recovering from a reset condition, the
device will default to SPI Mode 3. In addition, the SO pin will be in a high-impedance
state, and a high-to-low transition on the CS pin will be required to start a valid instruc-
tion. The SPI mode will be automatically selected on every falling edge of CS by
sampling the inactive clock state. After power is applied and V
datasheet value, the system should wait 20 ms before an operational mode is started.
AT45DB161B
CC
is at the minimum
9