IR3080MTRPBF International Rectifier, IR3080MTRPBF Datasheet - Page 17

• Manufacturer Part Number: IR3080MTRPBF
• Description: IC CONTROLLER PHASE 32LMLPQ
• Manufacturer: International Rectifier
• Series: XPhase™r

Specifications of IR3080MTRPBF

• Applications: Processor
• Current - Supply: 11mA
• Voltage - Supply: 9.5 V ~ 14 V
• Operating Temperature: 0°C ~ 100°C
• Mounting Type: Surface Mount
• Package / Case: 32-MLPQ
• Ic Function: Control IC With VCCVID And Overtemp Detect
• Supply Voltage Range: 9.5V To 14V
• Operating Temperature Range: 0°C To +100°C
• Digital Ic Case Style: MLPQ
• No. Of Pins: 32
• Filter Terminals: SMD
• Rohs Compliant: Yes
• Controller Type: PWM
• Package: 32-Lead MLPQ
• Circuit: X-Phase Control IC
• Switch Freq (khz): 150kHz to 1.0MHz
• Pbf: PbF Option Available
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: IR3080MPBFTR; IR3080MTRPBF; IR3080MTRPBFTR

The over-current delay can be reduced by adding a resistor in series with the SS/DEL capacitor. The delay
comparator’s offset voltage is reduced by the drop in the resistor caused by the discharge current. The value of the
series resistor should be 10KΩ or less to avoid interference with the soft start function.
If SS/DEL pin is pulled below 0.9V, the converter can be disabled.
Under Voltage Lockout (UVLO)
The UVLO function monitors the IR3080’s VCC supply pin and ensures that IR3080 has a high enough voltage to
power the internal circuit. The IR3080’s UVLO is set higher than the minimum operating voltage of compatible
Phase ICs thus providing UVLO protection for them as well. During power-up the fault latch is reset when VCC
exceeds 9.1V and there is no other fault. If the VCC voltage drops below 8.9V the fault latch will be set. For
converters using a separate 5V supply for gate driver bias an external UVLO circuit can be added to prevent any
operation until adequate voltage is present. A diode connected between the 5V supply and the SS/DEL pin provides
a simple 5V UVLO function. UVLO of the VIDPWR input is provided by the VID Power Good function. Adequate
voltage must be present at VIDPWR pin to allow VCCVID to reach 1.1V.
Over Current Protection (OCP)
The current limit threshold is set by a resistor connected between the OCSET and VDAC pins. If the IIN pin voltage,
which is proportional to the average current plus DAC voltage, exceeds the OCSET voltage, the over-current
protection is triggered.
VCC
(12V)
VIDPWR
(3.3V)
VCCVID
(1.2V)
VIDDEL
VIDPGD
SS/DEL
VOUT
PWRGD
IOUT
Page 17
3.91V
(VCCVID GATES
1.1V
FAULT MODE)
3.91V
1.3V
START-UP
(VOUT CHANGES DUE TO
LOAD AND VID CHANGES)
NORMAL OPERATION
OCP THRESHOLD
Figure 11. Operating Waveforms
OCP
DELAY
HICCUP OVER-CURRENT
PROTECTION
RE-START
AFTER OCP
IR3080PbF
POWER-DOWN
(VCC GATES
FAULT MODE)
8.9V
UVLO