L4973D3.3-013TR STMicroelectronics, L4973D3.3-013TR Datasheet - Page 4

• Manufacturer Part Number: L4973D3.3-013TR
• Description: IC REG SW STEP DOWN 3.5A 20-SOIC
• Manufacturer: STMicroelectronics
• Type: Step-Down (Buck)r

Specifications of L4973D3.3-013TR

• Internal Switch(s): Yes
• Synchronous Rectifier: No
• Number Of Outputs: 1
• Voltage - Output: 3.3V, 0.5 ~ 50 V
• Current - Output: 3.5A
• Frequency - Switching: 100kHz ~ 300kHz
• Voltage - Input: 8 ~ 55 V
• Operating Temperature: -40°C ~ 150°C
• Mounting Type: Surface Mount
• Package / Case: 20-SOIC (7.5mm Width)
• Power - Output: 4W
• Output Voltage: 5.1 V
• Output Current: 3.5 A
• Input Voltage: 8 V to 55 V
• Switching Frequency: 90 KHz to 110 KHz
• Operating Temperature Range: - 40 C to + 150 C
• Mounting Style: SMD/SMT
• Duty Cycle (max): 97 %
• For Use With: 497-4743 - BOARD EVAL FOR L4973X SW REG
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 497-3358-2

Pin settings
2.2
Note:
4/28
1
Pin description
Table 1.
The maximum power dissipation of the package must be observed.
13,14,15
DIP-18
4,5,6
7,8
2,3
11
10
18
12
16
9
1
N° Pin
Pin description
14,15,16,17
4,5,6,7
SO-20
8,9
2,3
12
11
10
20
13
18
1
COMP
BOOT
SYNC
Name
GND
OSC
OUT
V5.1
VFB
V
INH
CC
E/A output to be used for frequency compensation
A logic signal (active high) disables the device (sleep
mode operation). If not used it must be connected to
GND; if floating the device is disabled.
A capacitor connected between this pin and the output
allows to drive the internal D-MOS.
Input/Output synchronization.
Unregulated DC input voltage
Stepdown regulator output.
Stepdown feedback input. Connecting the output
directly to this pin results in an output voltage of 3.3 V
for the L4973V3.3 and 5.1 V for L4973V5.1. An external
resistive divider is required for higher output voltages.
For output voltage resistive divider is required for higher
output voltages. For output voltage less than 3.3 V, see
Note: 1
Reference voltage externally available.
Signal ground
An external resistor connected between the unregulated
input voltage and Pin 1 and a capacitor connected from
Pin 1 to ground fixes the switching frequency. (Line feed
forward is automatically obtained)
and
Figure 33.
Description
L4973