IP1001 International Rectifier, IP1001 Datasheet - Page 17

• Manufacturer Part Number: IP1001
• Description: IC PWR BLOCK SGL PHS 20A 256-BGA
• Manufacturer: International Rectifier
• Series: iPOWIR™r
• Type: Step-Down (Buck)r

Specifications of IP1001

• Internal Switch(s): Yes
• Synchronous Rectifier: Yes
• Number Of Outputs: 1
• Voltage - Output: 0.93 ~ 2 V
• Current - Output: 20A
• Frequency - Switching: 200kHz, 300kHz
• Voltage - Input: 3.3 ~ 12 V
• Operating Temperature: -40°C ~ 125°C
• Mounting Type: Surface Mount
• Package / Case: 256-BGA (218 bumps)
• Power - Output: 3.1W
• For Use With: IRDCIP1001-A - CONV SGL PHA SYNC BUCK 3.3-4.5V
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: *IP1001

www.irf.com
Refer to the following application notes for detailed guidelines and suggestions when implementing
iPOWIR Technology products:
AN-1028: Recommended Design, Integration and Rework Guidelines for International Rectifier’s
iPOWIR Technology BGA Packages
This paper discusses the assembly considerations that need to be taken when mounting iPOWIR BGA’s
on printed circuit boards. This includes soldering, pick and place, reflow, inspection, cleaning and
reworking recommendations.
AN-1029: Optimizing a PCB Layout for an iPOWIR Technology Design
This paper describes how to optimize the PCB layout design for both thermal and electrical performance.
This includes placement, routing, and via interconnect suggestions.
AN-1030: Applying iPOWIR Products in Your Thermal Environment
This paper explains how to use the Power Loss and SOA curves in the data sheet to validate if the
operating conditions and thermal environment are within the Safe Operating Area of the iPOWIR product.
CORNER ID
BALL A1
0.15 [.006] C
2X
6
[.016]
0.40
4X
BOTTOM VIEW
TOP VIEW
[.551]
14.00
[.032]
0.80
30X
B
14.00
[.551]
218X Ø
A
Mechanical Drawing
0.15 [.006]
0.08 [.003]
0.55 [.0216]
0.45 [.0178]
0.15 [.006] C
2X
6
C A B
C
0.12 [.005] C
7
5
C
(4X 1.0 [.039])
0.45 [.0177]
0.35 [.0138]
SIDE VIEW
2.66 [.1047]
2.46 [.0969]
3.11 [.1224]
2.81 [.1107]
NOTES:
1. DIMENSIONING & TOLERANCING PER ASME Y14.5M-1994.
2. DIMENSIONS ARE SHOWN IN MILLIMETERS [INCHES].
3. CONTROLLING DIMENSION: MILLIMETER
4. SOLDER BALL POSITION DESIGNATION PER JESD 95-1, SPP-010.
5
6
7
PRIMARY DATUM C (SEATING PLANE) IS DEFINED BY THE
SPHERICAL CROWNS OF THE SOLDER BALLS.
BILATERAL TOLERANCE ZONE IS APPLIED TO EACH SIDE OF THE
PACKAGE BODY.
SOLDER BALL DIAMETER IS MEASURED AT THE MAXIMUM SOLDER
BALL DIAMETER, IN A PLANE PARALLEL TO DATUM C.
iP1001
17