HCPL-J314-300E Avago Technologies US Inc., HCPL-J314-300E Datasheet - Page 12

• Manufacturer Part Number: HCPL-J314-300E
• Description: OPTOCOUPLER 1CH 0.6A 8-SMD GW
• Manufacturer: Avago Technologies US Inc.

Specifications of HCPL-J314-300E

• Package / Case: 8-SMD Gull Wing
• Voltage - Isolation: 3750Vrms
• Number Of Channels: 1, Unidirectional
• Current - Output / Channel: 600mA
• Propagation Delay High - Low @ If: 300ns @ 8mA
• Current - Dc Forward (if): 25mA
• Input Type: DC
• Output Type: Push-Pull, Totem-Pole
• Mounting Type: Surface Mount, Gull Wing
• Isolation Voltage: 3750 Vrms
• Maximum Fall Time: 50 ns
• Maximum Forward Diode Current: 25 mA
• Maximum Rise Time: 50 ns
• Minimum Forward Diode Voltage: 1.2 V
• Output Device: Integrated Photo IC
• Configuration: 1 Channel
• Maximum Forward Diode Voltage: 1.8 V
• Maximum Reverse Diode Voltage: 3 V
• Maximum Power Dissipation: 260 mW
• Maximum Operating Temperature: + 100 C
• Minimum Operating Temperature: - 40 C
• Number Of Elements: 1
• Forward Voltage: 1.8V
• Forward Current: 25mA
• Package Type: PDIP SMD
• Operating Temp Range: -40C to 100C
• Power Dissipation: 260mW
• Propagation Delay Time: 700ns
• Pin Count: 8
• Mounting: Surface Mount
• Reverse Breakdown Voltage: 3V
• Operating Temperature Classification: Industrial
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

Applications Information
Eliminating Negative IGBT Gate Drive
To keep the IGBT firmly off, the HCPL-J314 has a very low
maximum V
the lead inductance from the HCPL-J314 to the IGBT gate
and emitter (possibly by mounting the HCPL-J314 on a
small PC board directly above the IGBT) can eliminate the
need for negative IGBT gate drive in many applications
as shown in Figure 19. Care should be taken with such a
PC board design to avoid routing the IGBT collector or
CONTROL
Figure 19. Recommended LED drive and application circuit for HCPL-J314.
12
COLLECTOR
INPUT
+5 V
74XXX
OPEN
OL
270 Ω
specification of 1.0 V. Minimizing Rg and
1
2
3
4
HCPL-J314
8
7
6
5
0.1 µF
emitter traces close to the HCPL-J314 input as this can
result in unwanted coupling of transient signals into the
input of HCPL-J314 and degrade performance. (If the
IGBT drain must be routed near the HCPL-J314 input,
then the LED should be reverse biased when in the off
state, to prevent the transient signals coupled from the
IGBT drain from turning on the HCPL-J314.)
+
-
V
CC
Rg
= 15 V
Q1
Q2
3-PHASE
+ HVDC
- HVDC
AC