LQ038Q5DR01 Sharp Microelectronics, LQ038Q5DR01 Datasheet - Page 16

• Manufacturer Part Number: LQ038Q5DR01
• Description: LCD TFT 3.8" 320X240 QVGA
• Manufacturer: Sharp Microelectronics

Specifications of LQ038Q5DR01

• Display Type: LCD - Color
• Display Mode: *
• Viewing Area: 78.72mm L x 53.64mm W
• Dot Pixels: 320 x 240 (QVGA)
• Pixel Density: 320 x 240
• Module Size (w X H X T): 117.5 mm x 69.45 mm x 13.45 mm
• Viewing Area (w X H): 78.72 mm x 53.64 mm
• Backlighting: White
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Interface: -
• Backlight: -
• Dot Size: -
• Dot Pitch: -
• Lead Free Status / Rohs Status: Details
• Other names: 425-2484

12-2）Precautions in mounting
It is recommended to peel off the laminator immediately before the use, taking care of static
electricity.
them from the panel.
dry cloth. For stubborn dirties, wipe the part, breathing on it. Wipe off water drop or finger grease
immediately. Long contact with water may cause discoloration or spots. TFT-LCD module uses
glass which breaks or cracks easily if dropped or bumped on hard surface. Handle with care. Since
CMOS LSI is used in this module, take care of static electricity and earth your body when handling.
A) Working environment
B) Working procedures
But when the panel has stain or grease, we recommend to use adhesive tape to softly remove
When metal part of the TFT-LCD module (shielding lid and rear case) is soiled, wipe it with soft
Polarizer which is made of soft material and susceptible to flaw must be handled carefully.
Protective film (Laminator) is applied on the surface to protect it against scratches and dirties.
Precautions in peeling off the laminator
less than 20cm
When the laminator is peeled off, static electricity may cause dust to stick to the polarizer
surface. To avoid this, the following working environment is desirable.
･ Blow off dust with N2 blower for which static electricity preventive measure has been taken.
･ Since polarizer is vulnerable, wiping should be avoided.
a) Floor: Conductive treatment of 1MΩ or more on the tile
b) Clean room free form dust and with an adhesive mat on the doorway
c) Advisable humidity:50%∼70%
d) Workers shall wear conductive shoes, conductive work clothes, conductive gloves and an
a) Direct the wind of discharging blower somewhat downward to ensure that module is blown
b) Attach adhesive tape to the laminator part near discharging blower so as to protect
c) Peel off laminator, pulling adhesive tape slowly to your side taking 5 or more second.
d)On peeling off the laminator, pass the module to the next work process to prevent the
e) Method of removing dust from polarizer
earth band.
sufficiently. Keep the distance between module and discharging blower within 20 cm.
module to get dust.
polarizer against flaw.
discharging blower
(conductive mat or conductive paint on the tile)
module
Advisable temperature:15℃∼27℃
backlight cable
Direction of wind of blower
Adhesive tape