7023-D-E-700 LEDdynamics Inc, 7023-D-E-700 Datasheet - Page 5

• Manufacturer Part Number: 7023-D-E-700
• Description: LED DVR BUCKPLUS 700MA 6LD DIM
• Manufacturer: LEDdynamics Inc
• Series: 7023 BuckPlusr

Specifications of 7023-D-E-700

• Voltage - Input: 7 ~ 32V
• Voltage - Output: 32V
• Current - Output: 700mA
• Power (watts): 22.4W
• Mounting Type: Panel Mount
• Termination Style: Wire Leads
• Size / Dimension: 0.83" L x 0.83" W x 0.43" H (21.08mm x 21.08mm x 10.92mm)
• Operating Temperature: -40°C ~ 80°C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 788-1025

LEDdynamics, Inc.
802.728.4533 P
802.728.3800 F
[e-mail]
www.LUXdrive.com
Application Figures
Microprocessor Control
Other Control Applications
Connections
Figure 16 shows a typical interface for a Microchip PIC® or similar μcontroller. The reference output provides the
operating voltage for the processor (5V at up to 20mA current).
In addition to the configurations described above, the 7021/7023 may also be driven by a D to A converter. As in
the cases above, the analog control signal should have its ground common to LED-. Figure 2 shows the effective
controlrange of the analog input signal.
In all cases, the LEDs being driven should be located as close to the 7021/7023 LED output as possible. When the
use of long leads is required, use heavier gauge wire. For strobe or pulse applications, a wire length not
exceeding 6" should be used to maintain accurate timing.
The power input wires/traces should also be kept short. Where DC input units are located more than 18" from the
source, a 220μF, 50V capacitor should be placed across the input terminals as shown in Figure 18.
For applications where the use of header pins is inconvenient, a mating connector with 6" leads is available as an
accessory, or the 7023 part number may be used, which is supplied with 6” colored leads.
700 MA unit driving 6 High Power LEDs
V in
7021/7023
(VIN > 12VDC)
Figure 4.
LED+
LED-
7021HN - Harness for “N” type (4-wire)
7021HE - Harness for “E” & “I” type (6-wire)
7021HEP - Harness for “E” & “I” w/pot (6-wire w/pot)
©2010 LUXdrive, A Division of LEDdynamics, Inc. www.LUXdrive.com.
Specifications subject to change without notice. April, 2010 - Rev 2.2
7021/7023 BuckPlus
700mA unit driving 12 High Power LEDs
V in
Wide Range LED Power Module
7021/7023
DATA SHEET Page 5 of 8
(VIN > 24VDC)
Figure 5.
LED+
LED-
TM