151-0153 Rabbit Semiconductor, 151-0153 Datasheet - Page 14

• Manufacturer Part Number: 151-0153
• Description: ASSEMBLY - RABBITFLEX CABLES
• Manufacturer: Rabbit Semiconductor
• Series: RabbitFLEX™r

Specifications of 151-0153

• Accessory Type: Cable Assembly
• For Use With/related Products: BL300F
• Lead Free Status / RoHS Status: Vendor undefined / Vendor undefined

2.1.1 Hardware Connections
There are two steps to readying the RabbitFLEX BL300F for use with Dynamic C:
1. Connect the programming cable between the RabbitFLEX BL300F and the host PC where you will
install Dynamic C.
2. Connect the power supply.
The core module comes attached to the RabbitFLEX BL300F from the factory. The core module and the
board it is attached to are a matched set. They must be used together. Do not remove the core module and
attach a different core module to the RabbitFLEX board.
2.1.1.1 Connect Programming Cable
The programming cable completes the communications channel for downloading programs to the core
module. Once a program has been downloaded and is running, you can debug it over the programming
cable.
Connect the 10-pin connector labeled PROG on the programming cable to header J2 on the PowerCore
module as shown in
Figure
2.2.
Attach the other end (the DB9 connector) of the programming cable to a COM port on the host PC. Some
PCs now come equipped with a USB port and no COM port. In this case, you can connect the program-
ming cable’s DB9 connector to a RS-232/USB converter (Rabbit Part No. 540-0070), and then plug the
other end of the converter into the USB port of the host PC.
Figure 2.2 Programming and Power Connections
www.rabbit.com
8
Getting Started