VDIP1 FTDI, Future Technology Devices International Ltd, VDIP1 Datasheet - Page 11

MOD MCU-USB HOST CTLR 24-DIP

VDIP1

Manufacturer Part Number
VDIP1
Description
MOD MCU-USB HOST CTLR 24-DIP
Manufacturer
FTDI, Future Technology Devices International Ltd
Series
Vinculumr
Datasheet

Specifications of VDIP1

Main Purpose
Interface, USB 2.0 Host/Controller
Embedded
Yes, ASIC
Utilized Ic / Part
VNC1L-1A
Primary Attributes
Single A-Type Connector, UART / Parallel FIFO / SPI Interfaces
Secondary Attributes
Second USB Port is Available via Pins, Traffic LEDs
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Other names
768-1001
Document Reference No.: FT_000016
VDIP1 Vinculum VNC1L Module Datasheet Version 1.01
Clearance No.: FTDI# 131
`
3.6.2 SPI Slave Data Write Cycle
When in SPI mode, the timing of a write operation is shown in
Figure 3.4 – SPI Slave Data Write Cycle.
From Start - SPI CS must be held high for the entire write cycle, and must be taken low for at least
one clock period after t he write is co mpletedThe. first bit on SPI Data In is the R/W bit - inputting
a ‘0’ here a llows data to be written to the chip. The next bit is the address bit, ADD, which is used
to indicate whether the data register (‘0’) or the status register (‘1’) is written to. During the SPI
write cycle a byte of data can be input to SPI Data In on the next clock cycle after t he address bit,
MSBAfterfirst.t he data has been clocked in to the chip, t he status of SPI Data Out should be
checked to see if the data read was accepted. A ‘0’ level on SPI Data Out means that the data
write was accepted. A ‘1’ indicates that the internal buffer is full, and the write should be repeated.
Remember that CS must be held low for at least one clock period before being taken high again to
continue with the next read or write cycle.
Copyright © 2010 Future Technology Devices International Limited
10

Related parts for VDIP1