CY8CKIT-006 Cypress Semiconductor Corp, CY8CKIT-006 Datasheet - Page 2

• Manufacturer Part Number: CY8CKIT-006
• Description: KIT DEV PSOC3 LCD SEGMENT
• Manufacturer: Cypress Semiconductor Corp
• Series: PSOC™ 3r

Specifications of CY8CKIT-006

• Main Purpose: Displays, LCD Display
• Embedded: Yes, MCU, 32-Bit
• Primary Attributes: 448 addressable segments
• Secondary Attributes: Configurable LCD pin selection
• Description/function: Evaluation Kit
• Interface Type: USB
• Backlighting: No Backlighting
• Data Bus Width: 8 bit, 16 bit, 32 bit
• Maximum Operating Temperature: + 50 C
• Minimum Operating Temperature: 0 C
• Number Of Segments: 7
• Operating Supply Voltage: 12 V
• Operating Voltage: 3.3 V
• Pixel Format: 16 x 28
• Product: Display Modules
• Software: Software Included
• Touch Panel: No Touch Panel
• For Use With/related Products: PSoC 3
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Utilized Ic / Part: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 428-2994

Limitations and Known Issues
Documentation
Kit documents are located in the \Documentation and folder on the kit CD.
Refer to:
Release notes are located in the \Release_Notes subdirectory under the Documentation folder on
the kit CD.
Refer to CY8CKIT-006 PSoC3 LCD Drive Kit Release Notes.pdf
After installing the PSoC Creator and Programmer3.10, refer to the documentation as needed:
January 11, 2010
1. Low Power – when the demonstration firmware enters what appears to be Low Power
2. Battery Life – because low power is not actually implemented at this time, battery life is
3. Low Voltage – the kit does not currently support low voltage operation (single AA cell
4. Limited use of PSoC 3 pin P1[3] (SWO, JTAG TDO) as GPIO – the kit does not







mode (observe blank LCD display with periodic flash of “ZZZ”), the device is not actually
in a low power state.
continually reduced even when the display indicates sleep mode. The switch (SW1)
disconnects the battery. The battery is also disconnected when a wall supply is plugged
into J2 (power jack).
with boost conversion).
currently support the assignment of a Pins component to the PSoC 3 Pin P1[3] (User Pin
J4_7 GPIO1) in debug build mode. This will be fixed with final silicon and PSoC creator
releases.
CY8CKIT-006 PSoC3 LCD Drive Kit Users Guide.pdf
CY8CKIT-006 PSoC3 LCD Drive Kit Quick Start Guide.pdf
LCD Direct Drive Basics.pdf
PSoC 3_CY8C38_Family_Datasheet.pdf
PSoC 3_CY8C38_Family_Silicon_Errata.pdf
PSoC Creator
Programmer3.10
o
o
This will be completely corrected with the next revision of PSoC 3 silicon,
updated PSoC Creator components, and updated LCD Segment EVK
demonstration firmware.
This capability will be added after the next revision of PSoC 3 silicon, updated
PSoC Creator components, and updated LCD Segment EVK demonstration
firmware.

Help

Help

Documentation

Help Topics
Document No. 001-52795 Rev.*E
- 2 -
[+] Feedback