EVAL-AD7877EBZ Analog Devices Inc, EVAL-AD7877EBZ Datasheet - Page 29

• Manufacturer Part Number: EVAL-AD7877EBZ
• Description: BOARD EVALUATION FOR AD7877
• Manufacturer: Analog Devices Inc

Specifications of EVAL-AD7877EBZ

• Main Purpose: Interface, Touch Screen Controller
• Embedded: No
• Utilized Ic / Part: AD7877
• Primary Attributes: 4-Wire Resistive Touch Screen Controller, SPI Interface, On-Chip: Temp Sensor, Voltage Reference, 8-Bit DAC
• Secondary Attributes: USB GUI, LCD Noise Reduction Feature, 2.7 ~ 5.25 V, Wake Up on Touch Feature
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

WRITE TIMING
No serial interface operations can take place when CS is high.
To write to the AD7877, CS must be taken low. To write to the
device, a burst of 16 clock pulses is input to DCLK while the write
data is input to DIN. Data is clocked in on the rising edge of
DCLK. If multiple write operations are to be performed, CS must
be taken high after the end of each write operation before another
write operation can be performed by taking CS low again.
READING DATA
Data is available on the DOUT pin following the falling edge of
CS , when the device is being clocked. The MSB is clocked out
on the falling edge of CS , with subsequent data bits clocked out
on the falling edge of DCLK.
After CS is taken low and the device is clocked, the AD7877
outputs data from the register whose read address is currently
stored in Control Register 1. Once this data has been output,
the address increments automatically. CS must be taken high
between reads. When CS is taken low again, reading continues
Rev. B | Page 29 of 44
from the register whose read address is in Control Register 1,
provided that a write operation does not change the address. If
the register read address reaches 11111b, it is then reset to zero.
This feature allows all registers to be read out in sequence with-
out having to explicitly write all their addresses to the device.
Note that because data-words are 16 bits long, but the data
registers are only 12 bits long, or 8 bits in the case of GPIO
registers, the first four bits of a readback data-word are zeros, or
the first 8 bits in the case of a GPIO register.
V
The supply voltage to all pins associated with the serial interface
( DAV , DIN, DOUT, DCLK, CS , PENIRQ , and ALERT ) is
separate from the main V
V
processors whose supply voltage is less than the minimum
operating voltage of the AD7877, in fact, as low as 1.7 V.
DRIVE
DRIVE
pin. This allows the AD7877 to be connected directly to
PIN
CC
supply and is connected to the
AD7877