ISL54217EVAL1Z Intersil, ISL54217EVAL1Z Datasheet - Page 3
![no-image](/images/manufacturer_photos/0/3/341/intersil_sml.jpg)
ISL54217EVAL1Z
Manufacturer Part Number
ISL54217EVAL1Z
Description
EVALUATION BOARD FOR ISL54217
Manufacturer
Intersil
Specifications of ISL54217EVAL1Z
Main Purpose
Interface, 3:1 Multiplexer
Embedded
No
Utilized Ic / Part
ISL54217
Primary Attributes
2 x SP3T Analog Switch
Secondary Attributes
2.7 V ~ 4.6 V Supply
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
J13 (USB to DEVICE 1). In the USB2 mode, the USB2
switches will be turned ON and the computer will be able to
communicate with the USB device connected at J14 (USB to
DEVICE 2).
The board has two “A” type USB receptacles located on the
right side of the board, labeled USB TO DEVICE 1 (J13) and
USB to DEVICE 2 (J14). USB devices can be plugged
directly into these receptacles or through a standard USB
cable.
In USB1 mode, the USB host controller and USB device 1
will be connected through the internal USB1 switches of the
IC. In USB2 mode, the USB host controller and USB device
2 will be connected through the internal USB2 switches of
the IC. The USB switches are bi-directional, which allow the
host (computer) and downstream USB device to both send
and receive data.
Note: Before connecting the USB host controller at
connector J15, the headphones must be removed from the
headphone speaker jack, J20. This will prevent the audio
load from interfering with USB signal transmission.
The main purpose of the ISL54214 or ISL54217 device is to
allow the use of a common USB and Audio Headphone
Connector in Personal Media Players and other portable
battery powered equipment. Either a headphone will be in
the common connector to play music, or a USB cable from a
computer will be in the common connector to transmit digital
data into and out of the various transceiver sections of the
Media Player.
The BNC connector J11 (COM-) is in parallel with the D- line
of the J15 USB connector. The BNC connector J12 (COM+)
is in parallel with the D+ line of the J15 USB connector.
These BNC connectors can be used to connect test
equipment to evaluate the performance of the IC.
3
Application Note 1451
DESIGNATOR
JP1, JP2, JP3 D-/D+ Differential Probe Connection
JP4, JP5
J13, J14
J16, J17
J18, J19
JP6
JP7
J15
J20
J11
J12
U1
J1
J2
J4
J3
J5
J6
TABLE 1. BOARD COMPONENT DEFINITIONS
ISL54214IRTZ or ISL54217IRTZ IC
“B” type USB Receptacle
“A” type USB Receptacle
Left Stereo Audio Input
Right Stereo Audio Input
Headphone Speaker Jack
COM- BNC Connector
COM+ BNC Connector
VDD Positive Connection
VDD GND Connection
C1 Logic Control
C0 Logic Control
VBUS Connection for USB Device 1
VBUS Connection for USB Device 2
Jumpers to Enable S1 (C0) and S2 (C1) Toggle
Switches
Jumper to Enable VBUS voltage from Computer via
J15 Connector to USB Device 1
Jumper to Enable VBUS voltage from Computer via
J15 Connector to USB Device 2
DESCRIPTION
January 23, 2009
AN1451.0