EVAL-AD7797EBZ Analog Devices Inc, EVAL-AD7797EBZ Datasheet - Page 18

• Manufacturer Part Number: EVAL-AD7797EBZ
• Description: BOARD EVALUATION FOR AD7797
• Manufacturer: Analog Devices Inc

Specifications of EVAL-AD7797EBZ

• Number Of Adc's: 1
• Number Of Bits: 24
• Sampling Rate (per Second): 123
• Data Interface: Serial
• Inputs Per Adc: 1 Differential
• Input Range: ±VREF/128
• Power (typ) @ Conditions: 1.6mW @ 123SPS
• Voltage Supply Source: Analog and Digital
• Operating Temperature: -40°C ~ 85°C
• Utilized Ic / Part: AD7797
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

AD7796/AD7797
Single Conversion Mode
In single conversion mode, the AD7796/AD7797 are placed in
shutdown mode between conversions. When a single conver-
sion is initiated by setting MD2, MD1, and MD0 in the mode
register to 0, 0, and 1, respectively, the part powers up, performs
a single conversion, and then returns to shutdown mode. The
on-chip oscillator requires 1 ms to power-up. A conversion
requires a time period of 2 × t
indicate the completion of a conversion. When the data-word
has been read from the data register, DOUT/ RDY goes high. If
CS is low, DOUT/ RDY remains high until another conversion is
initiated and completed. The data register can be read several
times, if required, even when DOUT/ RDY has gone high.
DOUT/RDY
DOUT/RDY
SCLK
SCLK
DIN
DIN
CS
CS
ADC
0x08
. DOUT/ RDY goes low to
0x200A
0x58
Figure 15. Continuous Conversion
Figure 14. Single Conversion
Rev. A | Page 18 of 24
DATA
Continuous Conversion Mode
This is the default power-up mode. The AD7796/AD7797
continuously convert, and the RDY pin in the status register
goes low each time a conversion is complete. If CS is low, the
DOUT/ RDY line also goes low when a conversion is complete.
To read a conversion, the user can write to the communication
register, indicating that the next operation is a read of the data
register. The digital conversion is placed on the DOUT/ RDY
pin as soon as SCLK pulses are applied to the ADC. DOUT/ RDY
returns high when the conversion is read. The user can read this
register additional times, if required. However, the user must
ensure that the data register is not being accessed at the completion
of the next conversion, or the new conversion word is lost.
0x58
0x58
DATA
DATA