CDB5524 Cirrus Logic Inc, CDB5524 Datasheet - Page 50

• Manufacturer Part Number: CDB5524
• Description: EVAL BOARD FOR CS5524 ADC
• Manufacturer: Cirrus Logic Inc

Specifications of CDB5524

• Number Of Adc's: 1
• Number Of Bits: 24
• Sampling Rate (per Second): 617
• Data Interface: Serial
• Inputs Per Adc: 4 Differential
• Input Range: 0 ~ 5 V
• Power (typ) @ Conditions: 10.1mW @ 15SPS, 5 V
• Voltage Supply Source: Analog and Digital
• Operating Temperature: -40°C ~ 85°C
• Utilized Ic / Part: CS5524
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 598-1012

2.1 Clock Generator
XIN; XOUT - Crystal In; Crystal Out.
2.2 Control Pins and Serial Data I/O
CS - Chip Select.
SDI - Serial Data Input.
SDO - Serial Data Output.
SCLK - Serial Clock Input.
A0, A1 - Logic Outputs.
2.3 Measurement and Reference Inputs
AIN1+, AIN1-, AIN2+, AIN2- AIN3+, AIN3-, AIN4+, AIN4- - Differential Analog Input.
AIN1+, AIN2+, AIN3+, AIN4+, AIN5+, AIN6+, AIN7+, AIN8+ - Single-Ended Analog Input.
VREF+, VREF- - Voltage Reference Input.
50
A gate inside the chip is connected to these pins and can be used with a crystal to provide the
master clock for the device. Alternatively, an external (CMOS compatible) clock can be
supplied into the XIN pin to provide the master clock for the device.
When active low, the port will recognize SCLK. When high the SDO pin will output a high
impedance state. CS should be changed when SCLK = 0.
SDI is the input pin of the serial input port. Data will be input at a rate determined by SCLK.
A clock signal on this pin determines the input/output rate of the data for the SDI/SDO pins
respectively. This input is a Schmitt trigger to allow for slow rise time signals. The SCLK pin
will recognize clocks only when CS is low.
The logic states of A0-A1 mimic the states of the D22/D10-D23/D11 bits of the channel-setup
register. Logic Output 0 = AGND, and Logic Output 1 = VA+.
Differential input pins into the CS5522 and CS5524 devices.
Single-ended input pins into the CS5528.
Fully differential inputs which establish the voltage reference for the on-chip modulator.
SDO is the serial data output. It will output a high impedance state if CS = 1.
CS5521/22/23/24/28
DS317F8