STEVAL-ILL024V1 STMicroelectronics, STEVAL-ILL024V1 Datasheet - Page 11

• Manufacturer Part Number: STEVAL-ILL024V1
• Description: LED BOARD FOR STM32 STP16DP05
• Manufacturer: STMicroelectronics

Specifications of STEVAL-ILL024V1

• Design Resources: STEVAL-ILL024V1 BOM STEVAL-ILL024V1 Schematic
• Current - Output / Channel: 100mA
• Outputs And Type: 16, Non-Isolated
• Voltage - Output: 20V
• Features: Short-Circuit Protection
• Voltage - Input: 3 ~ 5.5V
• Utilized Ic / Part: STM32F103VB, STP16DP05
• Description/function: LED Display Demo System Control Unit
• Product: Display Modules
• For Use With: 497-9087 - LED MATRIX DISPLAY PANEL
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: STM32F103VB
• Other names: 497-9091

UM0767
3.2
●
●
Two control units and one display unit configuration
In this configuration there are two control units and a single display unit. One control unit
should be the master and the second should be the slave. By default, the system comes
with one master and one display panel.
The steps to operate the system in this configuration are listed below:
●
●
●
●
If needed, the display panels can be cascaded in series to create a longer display. To
cascade the display panels connect a 20-pin flat-ribbon cable from the J3 jumper (output) of
the first panel to the J1 jumper (input) of the second panel.
for cascading the display panels. Similarly, connect the FRC cable from the J3 jumper
(output) of the second panel to the J1 jumper (input) of the third panel and so on to create a
longer display. Up to 8 such display panels can be cascaded in series.
●
●
●
Step 12: press Esc on the keyboard to exit the selected mode.
Step 13: once out of the selected mode, the system resumes from step 9.
Step 1: configure one control unit as the master and the second control unit as the
slave, as explained in
Step 2: configure the address of the slave board using the on-board DIP switches, as
explained in
Step 3: connect the PS2 keyboard to the master control unit.
Step 4: connect the display panel to the slave control unit using a 20-pin flat-ribbon
cable. Insert the cable into the 10 x 2 header (Ext.Con) present on the slave at one side
and into the J1 header (input) on the display panel at the other side.
Step 5: connect the master and the slave control unit using a twisted pair cable. Ensure
that RS485+ at master is connected to RS485+ at slave and RS485- at master is
connected to RS485- at slave. Connections are made at the J18 screw type connector.
Figure 7
Step 6: power-up the master control unit, the slave control unit and the display panel
using DC power supplies.
Step 7: the LCD on the master and slave control unit shows “Press “#” to enter
ConfigurationMod”. This is displayed for 4 seconds. If the master and slave boards are
shows the RS485 connection topology.
Section
2.1.1.
Section
Doc ID 16147 Rev 1
2.1.2.
Figure 6
shows the connections
System configuration
11/30