CYII5SC1300-EVAL Cypress Semiconductor Corp, CYII5SC1300-EVAL Datasheet - Page 25

• Manufacturer Part Number: CYII5SC1300-EVAL
• Description: BOARD EVAL IMG SENS IBIS5-B-1300
• Manufacturer: Cypress Semiconductor Corp

Specifications of CYII5SC1300-EVAL

• Sensor Type: CMOS Imaging, Color (RGB)
• Sensing Range: 1.3 Megapixel
• Interface: Parallel/Serial
• Sensitivity: 106 fps
• Voltage - Supply: 3 V ~ 4.5 V
• Embedded: No
• Utilized Ic / Part: IBIS5-B-1300
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Contains lead / RoHS non-compliant

Windowing in Y-Direction
Reapply the Y_START pulse after loading a new Y-pointer value
into the YL_REG and YR_REG registers to load a new Y-pointer
into the Y-shift-register.
Every time a Y_START pulse appears, a frame calibration of the
output amplifier occurs.
Document #: 38-05710 Rev. *H
Figure 28. Windowing in Y-Direction
Initialization (Startup Behavior)
To avoid any high current consumption at startup, apply the
SYS_CLOCK signal as soon as possible after or even before
power on of the image sensor. After power on, apply
SYS_RESET for a minimum of five SYS_CLOCK periods to
ensure a proper reset of the on-chip sequencer and timing
circuitry. All internal registers are set to ‘0’ after SYS_RESET is
applied.
Because all the IBIS5-B-1300 control signals are active high,
apply a low level (before SYS_RESET occurs) to these pins at
start up to avoid latch up.
CYII5SM1300AB
Page 25 of 35
[+] Feedback