STM3210C-EVAL STMicroelectronics, STM3210C-EVAL Datasheet - Page 16

• Manufacturer Part Number: STM3210C-EVAL
• Description: EVAL BOARD FOR STM32F107VCT
• Manufacturer: STMicroelectronics
• Type: MCUr

Specifications of STM3210C-EVAL

• Contents: Fully Assembled Evaluation Board
• Processor To Be Evaluated: STM32F107VCT
• Processor Series: STM32
• Interface Type: RS-232, USB, I2C, JTAG
• Operating Supply Voltage: 5 V
• For Use With/related Products: STM32F107
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-8924

Demonstration architecture overview
16/21
How to use this demonstration:
●
●
●
●
●
●
Check that the jumper configuration on your STM3210C-EVAL board is correct, refer to
Table 2.: STM3210C-EVAL jumpers
Modify your PC network configuration
–
–
–
Connect your PC to the STM3210C-EVAL board using an Ethernet crossover cable.
Ping the board, by typing in the DOS command window: “ping 192.168.0.8”
In your internet browser, type “http://192.168.0.8” to load the STM32 web page
Now you can turn on/off the four LEDs on the STM3210C-EVAL board
Disable the Internet firewall installed on your PC (if it is enabled) and
bypass/deselect any proxy server in use.
Set your PC network card “Speed & Duplex” “to Auto Detect”, under Windows,
select: Control Panel->Network Connections->Local Area Connection ->
Properties->Configure->Advanced->Speed & Duplex
Change your PC IP address to 192.168.0.x (x different from 8): under Windows,
select: Control Panel->Network Connections->Local Area Connection ->
Properties->Internet Protocol (TCP/IP)->Properties->Use the following IP address
Doc ID 15787 Rev 1
UM0713