DEMOJM Freescale Semiconductor, DEMOJM Datasheet - Page 5

• Manufacturer Part Number: DEMOJM
• Description: KIT DEMO FOR JM MCU FAMILY
• Manufacturer: Freescale Semiconductor
• Series: ColdFire®r
• Type: MCUr

Specifications of DEMOJM

• Contents: Base Board, JM60 and JM128 Daughter Cards, Documentation and Software
• Processor To Be Evaluated: MC9S08JM60
• Data Bus Width: 32 bit
• Interface Type: USB
• Silicon Manufacturer: Freescale
• Core Architecture: Coldfire, HCS08
• Core Sub-architecture: Coldfire V1, HCS08
• Silicon Core Number: MCF51, MC9S08
• Silicon Family Name: Flexis - MCF51JM, Flexis - S08JM
• Rohs Compliant: Yes
• For Use With/related Products: MCF51JM128, MC9S08JM60
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Install PEMICRO Embedded
Multilink Toolkit
PEMICRO Embedded Multilink Toolkit
includes graphical utilities that run
on your computer and help speed up
your development. These utilities take
development beyond the hardware and
interact with the target microcontroller over
the same USB multilink reference design on
the board that allows you to debug using
CodeWarrior. Best of all, you can debug
your microcontroller in CodeWarrior while
simultaneously using one of the following
utilities: Logic Analyzer, Serial Grapher,
Terminal Window and Accelerometer Demo
Grapher. PEMICRO Embedded Multilink
Toolkit install is a one-time required step.
1. Insert provided DVD into computer and a menu
2. Click on “Install PEMICRO Toolkit.” This will
3. Follow the on-screen instructions to complete
For more information on PEMICRO
Embedded Multilink Toolkit read the
DEMOJM User Manual (DEMOJMUM.pdf)
included in the “Documentation” section of
DVD. For new and upgraded utilities to the
PEMICRO Embedded Multilink Toolkit, visit
www.pemicro.com.
will appear.
launch the toolkit installer.
installation.
STEP
3
Connect Board to Computer
USB driver installation is a one-time
required step, to be completed after
CodeWarrior installation.
1. Remove DEMOJM base board and green
2. Plug in the green daughter card to DEMOJM
3. Connect provided A to B gray USB cable from
4. Operating system will recognize your board
5. Follow on-screen instructions until all USB
MC9S08JM60 daughter from anti-static bags.
base board aligning pin 1 arrows.
a free USB port on your computer to the USB
connector on the board.
as new hardware and will prompt you to
install the USB drivers. Choose recommended
option to install the software automatically.
USB drivers for your board were pre-loaded in
CodeWarrior installation.
driver installations are complete. The green
USB LED on-board should illuminate.
STEP
4