DEMOJM Freescale Semiconductor, DEMOJM Datasheet - Page 8

• Manufacturer Part Number: DEMOJM
• Description: KIT DEMO FOR JM MCU FAMILY
• Manufacturer: Freescale Semiconductor
• Series: ColdFire®r
• Type: MCUr

Specifications of DEMOJM

• Contents: Base Board, JM60 and JM128 Daughter Cards, Documentation and Software
• Processor To Be Evaluated: MC9S08JM60
• Data Bus Width: 32 bit
• Interface Type: USB
• Silicon Manufacturer: Freescale
• Core Architecture: Coldfire, HCS08
• Core Sub-architecture: Coldfire V1, HCS08
• Silicon Core Number: MCF51, MC9S08
• Silicon Family Name: Flexis - MCF51JM, Flexis - S08JM
• Rohs Compliant: Yes
• For Use With/related Products: MCF51JM128, MC9S08JM60
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Install PEMICRO Embedded
Multilink Toolkit
PEMICRO Embedded Multilink Toolkit
includes graphical utilities that run
on your computer and help speed up
your development. These utilities take
development beyond the hardware and
interact with the target microcontroller over
the same USB multilink reference design on
the board that allows you to debug using
CodeWarrior. Best of all, you can debug
your microcontroller in CodeWarrior while
simultaneously using one of the following
utilities: Logic Analyzer, Serial Grapher,
Terminal Window and Accelerometer Demo
Grapher. PEMICRO Embedded Multilink
Toolkit install is a one-time required step.
1. Insert provided DVD into computer and a menu
2. Click on “Install PEMICRO Toolkit.” This will
3. Follow the on-screen instructions to
For more information on PEMICRO Embedded
Multilink Toolkit read the DEMOJM User
Manual (DEMOJMUM.pdf) included in the
“Documentation” section of DVD. For new and
upgraded utilities to PEMICRO Embedded
Multilink Toolkit, visit www.pemicro.com.
DEMOJM—Quick Start Guide
will appear.
launch the toolkit installer.
complete installation.
STEP
3
Connect Board to Computer
USB driver installation is a one-time
required step, to be completed after
CodeWarrior installation.
1. Remove DEMOJM base board and the red
2. Plug in the red daughter card to DEMOJM base
3. Connect provided A to B gray USB cable from
4. Operating system will recognize your board
5. Follow on-screen instructions until all USB
MCF51JM128 daughter card from
anti-static bags.
board aligning pin 1 arrows.
a free USB port on your computer to the USB
connector on the board.
as new hardware and will prompt you to
install the USB drivers. Choose recommended
option to install the software automatically.
USB drivers for your board were pre-loaded in
CodeWarrior installation.
driver installations are complete. The green
USB LED on-board should illuminate.
STEP
4