AT91SAM9G10-EK Atmel, AT91SAM9G10-EK Datasheet - Page 14

• Manufacturer Part Number: AT91SAM9G10-EK
• Description: KIT DEV FOR SAM9G10 ARM
• Manufacturer: Atmel
• Type: MCUr

Specifications of AT91SAM9G10-EK

• Contents: Board, Cables, Power Supply
• Silicon Manufacturer: Atmel
• Core Architecture: AVR
• Kit Contents: Board
• Svhc: No SVHC (15-Dec-2010)
• Mcu Supported Families: AT91SAM9G10, ARM926EJ-S
• Tool / Board Applications: Microcontroller
• Rohs Compliant: Yes
• For Use With/related Products: *
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

6479A–ATARM–26-May-09
3-2
Reset Controller (RSTC)
Shutdown Controller (SHDWC)
Clock Generator (CKGR)
Power Management Controller (PMC)
Advanced Interrupt Controller (AIC)
Debug Unit (DBGU)
Periodic Interval Timer (PIT)
Watchdog Timer (WDT)
Real-Time Timer (RTT)
Three 32-bit Parallel Input/Output Controllers (PIO) PIOA, PIOB and PIOC
Nineteen Peripheral DMA (PDC) Channels
Multimedia Card Interface (MCI)
Three Synchronous Serial Controllers (SSC)
Three Universal Synchronous/Asynchronous Receiver Transmitters (USART)
– Clock Generator and Power Management Controller
– Advanced Interrupt Controller and Debug Unit
– Periodic Interval Timer, Watchdog Timer and Real-time Timer
– Three 32-bit PIO Controllers
– Based on Power-on Reset Cells, Reset Source Identification and Reset Output Control
– Programmable Shutdown Pin Control and Wake-up Circuitry
– 32.768 kHz Low-power Oscillator on Battery Backup Power Supply, Providing a Permanent Slow
– 3 to 20 MHz On-chip Oscillator and two PLLs
– Very Slow Clock Operating Mode, Software Programmable Power Optimization Capabilities
– Four Programmable External Clock Signals
– Individually Maskable, Eight-level Priority, Vectored Interrupt Sources
– Three External Interrupt Sources and One Fast Interrupt Source, Spurious Interrupt Protected
– 2-wire USART and Support for Debug Communication Channel, Programmable ICE Access
– 20-bit Interval Timer plus 12-bit Interval Counter
– Key Protected, Programmable Only Once, Windowed 12-bit Counter, Running at Slow Clock
– 32-bit Free-running Backup Counter Running at Slow Clock
– 96 Programmable I/O Lines Multiplexed with up to Two Peripheral I/Os
– Input Change Interrupt Capability on Each I/O Line
– Individually Programmable Open-drain, Pull-up Resistor and Synchronous Output
– Compliant with Multimedia Cards and SDCards
– Automatic Protocol Control and Fast Automatic Data Transfers with PDC, MMC and SDCard
– Independent Clock and Frame Sync Signals for Each Receiver and Transmitter
– I²S Analog Interface Support, Time Division Multiplex Support
– High-speed Continuous Data Stream Capabilities with 32-bit Data Transfer
– Individual Baud Rate Generator, IrDA
Clock
Prevention
Compliant
®
Infrared Modulation/Demodulation
AT91SAM9G10-EK Evaluation Board User Guide