CY3209-EXPRESSEVK Cypress Semiconductor Corp, CY3209-EXPRESSEVK Datasheet - Page 60

• Manufacturer Part Number: CY3209-EXPRESSEVK
• Description: EVAL KIT WORLDTOUR2
• Manufacturer: Cypress Semiconductor Corp
• Series: PSoc Express™r
• Type: MCUr

Specifications of CY3209-EXPRESSEVK

• Contents: Evaluation Board, LCD Module, MiniProng Programming Unit, 2 AWP24S, cable, 9V battery and software
• Silicon Manufacturer: Cypress
• Core Architecture: PSoC
• Silicon Family Name: PSoC
• Kit Contents: Express Eval Board, LCD Module, Programmer, Two 2.4GHz Radios, Battery, Cables, Literature And Software
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: -
• Lead Free Status / Rohs Status: Supplier Unconfirmed
• Other names: 428-2025

Cypress WirelessUSB™ Master/Slave Lab 1
7.2.10
7.2.11
60
Program the PSoC Device
1. Disconnect any power sources from the demonstration board.
2. Remove the jumpers between J5 and J6.
3. Program the part via J6 as described in
4. Install jumpers on the following pin combinations:
Test Your Project on the Demonstration Board
1. Ensure the slave project has been programmed into the bottom left quadrant of the demonstra-
2. Install radio modules on J3 and J4 of the demonstration board. Align Pin 1 of each radio module
3. Power the board with a 9V battery (provided with the kit) or an optional 6–14V DC wall
4. Within 20 seconds of each other, press and release the pushbuttons on the bottom left and bot-
5. Adjust the potentiometer on the slave (bottom left quadrant). Observe the master’s multi-digit
6. Observe the following relationship between the multi-digit LED display on the master and the
Projects section on page
Figure 7-4. CY3209WUSBMasterLab Jumper Settings
tion board and that the jumpers specified in
installed.
with Pin 1 of its respective board connector.
transformer.
tom right quadrants of the demonstration board. This accomplishes a binding process in which
the slave obtains the master's ID and stores it in non-volatile memory. The master's ID provides
information the slave needs to successfully exchange application data with the master.
LED display and the slave’s LED.
single LED on the slave:
■
■
■
J5 J6
1
0-999
1000-1999
>2000
1
→
→
→
LED is Off
LED is On
LED is Blinking
10.
Programming Instructions for CY3209 PSoC Express
CY3209-ExpressEVK Kit Guide, Doc. # 001-16798 Rev. **
Program the PSoC Device on page 54
have been