CY3209-EXPRESSEVK Cypress Semiconductor Corp, CY3209-EXPRESSEVK Datasheet - Page 9

• Manufacturer Part Number: CY3209-EXPRESSEVK
• Description: EVAL KIT WORLDTOUR2
• Manufacturer: Cypress Semiconductor Corp
• Series: PSoc Express™r
• Type: MCUr

Specifications of CY3209-EXPRESSEVK

• Contents: Evaluation Board, LCD Module, MiniProng Programming Unit, 2 AWP24S, cable, 9V battery and software
• Silicon Manufacturer: Cypress
• Core Architecture: PSoC
• Silicon Family Name: PSoC
• Kit Contents: Express Eval Board, LCD Module, Programmer, Two 2.4GHz Radios, Battery, Cables, Literature And Software
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: -
• Lead Free Status / Rohs Status: Supplier Unconfirmed
• Other names: 428-2025

PSoC Express
Explore the Hands-on Example Projects
Select other projects to build from the following chapters in the Kit Guide
CY3209-ExpressEVK Quick Start Guide, Spec. # 001-22859 Rev. **
3.
Chapter 1: Introduction
Chapter 2: First Example
This example implements a pushbutton used to control a decaying LED.
Chapter 3: I2C Master/Slave Lab
This lab creates two projects: an I2C slave and an I2C master. The I2C master device reads a voltage value
from the slave and displays the value on a four digit LED display. The master also writes a control value to
the slave device to set an LED to Off, On, or Blinking, depending on the voltage level read from the slave.
Chapter 4: USB-UART Lab
This project uses the USB-UART driver to demonstrate the ability to monitor and control a PSoC device with
a PC using a virtual COM port on a USB hardware connection. The project has a voltage input and an LED
that supports three states: Off, On, and Blinking. The LED state is controlled by an Interface Valuator.
Chapter 5: CapSense Lab
This project creates four capacitance sensing buttons that individually control four LEDs.
Chapter 6: LCD Lab
This project displays a voltage input as a numeric value and as a bar graph on an LCD display.
Chapter 7: Cypress WirelessUSB™ Master/Slave Lab 1
This lab creates two projects: a WirelessUSB slave and a WirelessUSB master. The WirelessUSB master
device reads a voltage value from the slave and displays the value on a four digit LED display. The master
also writes a control value to the slave device to set an LED to Off, On, or Blinking depending on the voltage
level read from the slave.
1
2. Read Chapter 1 of the Kit Guide to learn the following subjects:
Open the CY3209-ExpressEVK Kit Guide on the CD's /Documentation folder.
a. How to add drivers and valuators to a PSoC Express Design.
b. How to install your MiniProg programmer.
c. How to program the demonstration board.
d. Conventions used in the CY3209-ExpressEVK Kit Guide.
CY3209-ExpressEVK Example Projects
9