DEMO9S08JS16 Freescale Semiconductor, DEMO9S08JS16 Datasheet - Page 28

• Manufacturer Part Number: DEMO9S08JS16
• Description: BOARD DEMO FOR JS16 FAMILY
• Manufacturer: Freescale Semiconductor
• Type: MCUr

Specifications of DEMO9S08JS16

• Contents: 2 Boards, Cable, Documentation, DVD
• Processor To Be Evaluated: MC9S08JS16
• Data Bus Width: 8 bit
• Interface Type: USB
• Operating Supply Voltage: 5 V
• Silicon Manufacturer: Freescale
• Core Architecture: HCS08
• Core Sub-architecture: HCS08
• Silicon Core Number: MC9S08
• Silicon Family Name: S08JS
• Rohs Compliant: Yes
• For Use With/related Products: MC9S08JS16
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

7
7.1
7.2
24
6.5.2.2
DEMONSTRATION MICROCONTROLLER APPLICATIONS
Logic Analyzer Application
Serial Accelerometer Application
Word Formatted Data
There are three commands which may be accepted. All commands must end
in the special characters #$0D and #$0A which are CR (carriage return) and
LF (line feed). The accepted commands are:
The nnnn values are 0000-FFFF and correspond in order to the data
displayed on both the graph and bar graphs as follows: X/A, Y/B, Z/C, W/D.
The nnnn values are 0000-FFFF and correspond in order to the data
displayed the graphing component as follows: X, Y, Z, W.
The nnnn values are 0000-FFFF and correspond in order to the data
displayed on the bar graph component as follows: A, B, C, D.
The following microcontroller applications are designed to run on the JM
processors.
The function of the Logic Analyzer Application is to play a different tone and
illuminate a different LED for each of the buttons pressed on the DEMOJM
board. The potentiometer controls the intensity of an LED on the DEMOJM
board, via a PWM signal.
This microcontroller application samples the state of the on-board three-axis
accelerometer using on-chip A/D converter channels. This data is converted
into ASCII characters and sent out using the serial pins of the JM processor.
These serial pins may be connected to P&E’s virtual serial port (which is part
of the Embedded Multilink design). Jumper J4 controls this connection.
P&E has two PC-based P&E Embedded Multilink Toolkit applications which
allow the serial port data generated by this application to be graphed. These
are documented in Section 6.4 - Accelerometer Demo Application and
Section 6.5 - Serial Grapher Application.
nnnn,nnnn,nnnn,nnnn
nnnn:nnnn:nnnn:nnnn
nnnn=nnnn=nnnn=nnnn
DEMO9S08JS16 User Manual