RCDK8C Renesas Electronics America, RCDK8C Datasheet - Page 17

• Manufacturer Part Number: RCDK8C
• Description: KIT DEV EVAL FOR CAN R8C/23
• Manufacturer: Renesas Electronics America
• Type: MCUr

Specifications of RCDK8C

• Contents: 2 Target Boards with CAN Transceiver, E8 Emulator, Cables and CD-ROM
• For Use With/related Products: R8C/23
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

6.7.Oscillator Sources
A crystal oscillator is fitted on the board and used to supply the main clock input to the Renesas microcontroller.
Table 6-13: Oscillator details the oscillators that are fitted and alternative footprints provided on this board:
6.8.Reset Circuit
The CPU Board includes a simple latch circuit that links the mode selection and reset circuit. This provides an easy method for swapping
the device between Boot Mode and Single Chip Mode. This circuit is not required on customers’ boards as it is intended for providing
easy evaluation of the operating modes of the device on the Renesas Starter Kit. Please refer to the hardware manual for more
information on the requirements of the reset circuit.
The Reset circuit operates by latching the state of the boot switch on pressing the reset button. This control is subsequently used to
modify the MODE pin states as required.
The MODE pin should change state only while the reset signal is active to avoid possible device damage.
The reset is held in the active state for a fixed period by a pair of resistors and a capacitor. Please check the reset requirements carefully
to ensure the reset circuit on the customers’ board meets all the reset timing requirements.
6.9.LIN Interface
This Renesas Starter Kit has hardware LIN interface. The interface is available on connector ‘J10’. The connector ‘J9’ functions as
power connector for LIN. The device can be operated either in Master node or Slave node. The device performs LIN communication in
cooperation with Timer RA and UART0.
For mode details on LIN interface please refer to R8C/23 Group Hardware Manual.
6.10.CAN Interface
This Renesas Starter Kit has CAN interface. The interface is available on connector ‘J12’.
For mode details on LIN interface please refer to R8C/23 Group Hardware Manual.
Component
Crystal (X1)
Fitted
Table 6-13: Oscillator
20 MHz (HC/49U package)
13