ATEVK1104S Atmel, ATEVK1104S Datasheet - Page 79

• Manufacturer Part Number: ATEVK1104S
• Description: KIT EVAL FOR AT32UC
• Manufacturer: Atmel
• Series: AVR®32 UC3r
• Type: MCUr

Specifications of ATEVK1104S

• Contents: Board, Cables
• Tool Type: Development Kit
• Cpu Core: AVR 32
• Data Bus Width: 32 bit
• Processor Series: AT32
• Processor To Be Evaluated: AT32UC3A3256S
• Interface Type: USB, JTAG, SD Card, Nexus, MMC
• Core Architecture: AVR
• Operating Supply Voltage: 5.5 V
• For Use With/related Products: *
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

13. Errata
13.1
13.1.1
13.1.2
13.1.3
32072C–AVR32–2010/03
Rev. G
Processor and Architecture
MPU
ADC
1. LDM instruction with PC in the register list and without ++ increments Rp
2. Hardware breakpoints on MAC instructions may corrupt the destination registerof the
3. When the main clock is RCSYS, TIMER_CLOCK5 is equal to PBA clock
4. Clock sources will not be stopped in STATIC sleep mode if the difference between
1. Privilege violation when using interrupts in application mode with protected system
1. Sleep Mode activation needs additional A to D conversion
For LDM with PC in the register list: the instruction behaves as if the ++ field is always set, ie
the pointer is always updated. This happens even if the ++ field is cleared. Specifically, the
increment of the pointer is done in parallel with the testing of R12.
Fix/Workaround
None.
MAC instruction.
Fix/Workaround
Place breakpoints on earlier or later instructions.
When the main clock is generated from RCSYS, TIMER_CLOCK5 is equal to PBA Clock
and not PBA Clock / 128.
Fix/workaround
None.
CPU and PBx division factor is too big.
If the division factor between the CPU/HSB and PBx frequencies is more than 4 when going
to a sleep mode where the system RC oscillator is turned off, then high speed clock sources
will not be turned off. This will result in a significantly higher power consumption during the
sleep mode.
Fix/Workaround
Before going to sleep modes where the system RC oscillator is stopped, make sure that the
factor between the CPU/HSB and PBx frequencies is less than or equal to 4.
stack
If the system stack is protected by the MPU and an interrupt occurs in application mode, an
MPU DTLB exception will occur.
Fix/Workaround
Make a DTLB Protection (Write) exception handler which permits the interrupt request to be
handled in privileged mode.
If the ADC sleep mode is activated when the ADC is idle the ADC will not enter sleep mode
before after the next AD conversion.
Fix/Workaround
Activate the sleep mode in the mode register and then perform an AD conversion.
AT32UC3A3/A4
79