101-0577 Rabbit Semiconductor, 101-0577 Datasheet - Page 61

• Manufacturer Part Number: 101-0577
• Description: KIT DEV FOR BL2500 COYOTE
• Manufacturer: Rabbit Semiconductor
• Series: Coyoter
• Type: Single Board Computers (SBC)r

Specifications of 101-0577

• Contents: SBC, Dev. Board, AC Adapter, Cable and Dynamic C® CD-ROM
• Product: Modules
• Data Bus Width: 10 bit
• Processor Type: Rabbit 3000
• Sram: 128 KB
• Flash: 256 KB
• Number Of I/os: 24
• Backup Battery: 3 V Lithium Coin Type
• Operating Voltage: 8 V to 40 V
• Power Consumption: 1 W
• Board Size: 100 mm x 100 mm x 29 mm
• Description/function: Computer Module
• Interface Type: Ethernet
• For Use With/related Products: BL2510
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

PARAMETERS
RETURN VALUE
SEE ALSO
PARAMETERS
RETURN VALUE
SEE ALSO
User’s Manual
int anaOutCalib(int channel, int value1,
int anaOutEERd(unsigned int channel);
Calibrates the response of the D/A converter channel as a linear function using the two conversion points
provided. Values are calculated and placed into global table _dacCalibS for analog inputs to be stored
later into simulated EEPROM using the function anaOutEEWr().
Each channel will have a linear constant and a voltage offset.
channel is the output channel 0 or 1: 0 for DA0, 1 for DA1
value1 is the first D/A converter value (0–1023), usually a value of 310 that corresponds to 1.0 V
volts1 is the voltage corresponding to the first D/A converter value (0–3.3 V or V
value2 is the second D/A converter value (0–1023), usually a value of 930 that corresponds to 3.0 V
volts2 is the voltage corresponding to the second D/A converter value (0–3.3 V or V
0 if successful
-1 if not able to make calibration constants
Reads the calibration constants, gain, and offset for an output based on its designated channel code
position into global table
SAMPLES\USERBLOCK
addresses available for use in your program.
channel is the output channel 0 or 1: 0 for DA0, 1 for DA1
0 if successful
-1 if invalid address or range
float volts1,int value2, float volts2);
pwmOut, anaOutEERd, anaOutEEWr
anaOutEEWr, anaOutCalib
NOTE: This function cannot be run in RAM.
_adcCalibS
to get the addresses reserved for the calibration data constants and the
. Use the sample program
USERBLOCK_INFO.C
ref
)
ref
)
in
55