101-0577 Rabbit Semiconductor, 101-0577 Datasheet - Page 69

• Manufacturer Part Number: 101-0577
• Description: KIT DEV FOR BL2500 COYOTE
• Manufacturer: Rabbit Semiconductor
• Series: Coyoter
• Type: Single Board Computers (SBC)r

Specifications of 101-0577

• Contents: SBC, Dev. Board, AC Adapter, Cable and Dynamic C® CD-ROM
• Product: Modules
• Data Bus Width: 10 bit
• Processor Type: Rabbit 3000
• Sram: 128 KB
• Flash: 256 KB
• Number Of I/os: 24
• Backup Battery: 3 V Lithium Coin Type
• Operating Voltage: 8 V to 40 V
• Power Consumption: 1 W
• Board Size: 100 mm x 100 mm x 29 mm
• Description/function: Computer Module
• Interface Type: Ethernet
• For Use With/related Products: BL2510
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

5.2.3 Run the PINGME.C Demo
Connect the crossover cable from your computer’s Ethernet port to the Coyote’s RJ-45
Ethernet connector. Open this sample program from the
compile the program, and start it running under Dynamic C. When the program starts run-
ning, the green LNK light on the Coyote should be on to indicate an Ethernet connection is
made. (Note: If the LNK light does not light, you may not have a crossover cable, or if you
are using a hub perhaps the power is off on the hub.)
The next step is to ping the board from your PC. This can be done by bringing up the MS-
DOS window and running the ping program:
or by Start > Run
and typing the command
Notice that the orange ACT light flashes on the Coyote while the ping is taking place, and
indicates the transfer of data. The ping routine will ping the board four times and write a
summary message on the screen describing the operation.
User’s Manual
ping 10.10.6.100
ping 10.10.6.100
SAMPLES\TCPIP\ICMP
folder,
63