ST7MDT1-EPB2/US STMicroelectronics, ST7MDT1-EPB2/US Datasheet - Page 8
![no-image](/images/manufacturer_photos/0/6/637/stmicroelectronics_sml.jpg)
ST7MDT1-EPB2/US
Manufacturer Part Number
ST7MDT1-EPB2/US
Description
BOARD PROGRAMMING ST7
Manufacturer
STMicroelectronics
Type
MCUr
Datasheet
1.ST7MDTS1-EPBUS.pdf
(15 pages)
Specifications of ST7MDT1-EPB2/US
Contents
Programmer Board
For Use With/related Products
ST72104, ST72215, ST72216, ST72254
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
1 Getting Started
1.4
8/15
This section provides information to help you setup your application
board for in-circuit programming of your ST7.
To take advantage of ICP you must have an ICC connector (10-pin
HE-10 type) installed on your application board allowing you to
connect it to your programming board with the provided ICC cable
(10-pin ribbon cable). This connection is illustrated in
Figure 3.
4.
Use ST7 Visual Programmer to program your device. For more detailed information about
its use, refer to the software’s online help.
Using an in-circuit programming connection
Some ST7-EPB programmers allow in-circuit programming (ICP) of supported ST7 Flash
microcontrollers, thanks to the In-Circuit Communication (ICC) protocol developed for ST7.
Figure 4.
Lock the device in place by lowering the lever again.
Installing MCU in a ZIF socket
In-Circuit Communication interface
UM0028 Rev 4
Pin 1 indicator
Pin
Pin 1 indicator
Figure 4
.
HE-10 type connector
ST7-EPB