ST7MDTH1-EPB/US STMicroelectronics, ST7MDTH1-EPB/US Datasheet - Page 7

• Manufacturer Part Number: ST7MDTH1-EPB/US
• Description: BOARD PROGRAMMING FOR ST7
• Manufacturer: STMicroelectronics
• Type: MCUr

Specifications of ST7MDTH1-EPB/US

• Contents: Programmer Board
• For Use With/related Products: ST7Hub
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

ST7-EPB
1.2
Note:
Note:
1.3
Caution:
Figure 2.
Setting up your ST7-EPB
To setup your ST7-EPB programming board:
1.
2.
Be sure to use the parallel cable provided with your kit — using a longer parallel cable may
cause malfunctions.
Connect the cable directly between the host PC and the programming board — inserting
additional cables or switch boxes between the host PC and the programming board may
cause malfunctions.
If a dongle (a hardware key required by some software packages) is already connected to
the PC’s parallel port, it should not interfere with the programming board. However, if a
malfunction of the board occurs, please remove the dongle and reconnect your EPB.
1.
The board can be supplied from the integrated power supply provided with the board, or
from an external +15 V
2.
Using the programming sockets
All ST7-EPBs come with one or more sockets for programming. The sockets that are
available to you for programming will vary depending on the packages for the ST7 sub-
family that your programming board supports.
Regardless of the type of socket, when installing an ST7 for programming you must ensure
that pin 1 of the ST7 corresponds with pin 1 of the socket.
To install your ST7:
1.
2.
3.
Take care when placing the device into a socket so as not to damage the device or the
board. Forcing the MCU into the socket may result in damage to the socket.
Shut down and power-off the host PC.
Connect one end of the supplied parallel cable to the EPB’s P1 connector and the
other end to one of the host PC’s parallel ports (LPT1 or LPT2).
Connect the power supply to the programming board. Ensure that the power supply is
adapted to the mains voltage and outlet type used in your country.
Power on the host PC.
Set up the EPB as described in
Identify the socket for your device package on the programming board.
Open the socket, or lift the lever (for ZIF sockets) and place the device into the socket
with pin 1 matching the pin 1 indicator on the programming board.
Parts delivered with ST7-EPBs (not to scale)
DC
/ 0.5 A power supply.
UM0028 Rev 4
Section 1.2
Optional
4
on page 7.
1 Getting Started
7/15