C8051F411EK Silicon Laboratories Inc, C8051F411EK Datasheet - Page 62

• Manufacturer Part Number: C8051F411EK
• Description: KIT EVAL FOR C8051F411
• Manufacturer: Silicon Laboratories Inc
• Type: MCUr

Specifications of C8051F411EK

• Contents: Evaluation Board, CD-ROM, USB Cable, Batteries and User Guide
• Processor To Be Evaluated: C8051F41x
• Interface Type: USB
• Silicon Manufacturer: Silicon Labs
• Core Architecture: 8051
• Silicon Core Number: C8051F411
• Silicon Family Name: C8051F41x
• Kit Contents: LCD Based Evaluation Board, USB Cable, Software CD And Quick-Start Guide
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• For Use With/related Products: Silicon Laboratories C8051F41x
• For Use With: 336-1315 - KIT REF DESIGN VOICE RECORD F41X
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 336-1317

C8051F410/1/2/3
62
Bit7:
Bit6:
Bit5:
Bit4:
Bit3:
Bit2:
Bits1-0:
AD0EN BURSTEN AD0INT AD0BUSY AD0WINT AD0LJST AD0CM1 AD0CM0 00000000
R/W
Bit7
AD0EN: ADC0 Enable Bit.
0: ADC0 Disabled. ADC0 is in low-power shutdown.
1: ADC0 Enabled. ADC0 is active and ready for data conversions.
BURSTEN: ADC0 Burst Mode Enable Bit.
0: ADC0 Burst Mode Disabled.
1: ADC0 Burst Mode Enabled.
AD0INT: ADC0 Conversion Complete Interrupt Flag.
0: ADC0 has not completed a data conversion since the last time AD0INT was cleared.
1: ADC0 has completed a data conversion.
AD0BUSY: ADC0 Busy Bit.
Read:
0: ADC0 conversion is complete or a conversion is not currently in progress. AD0INT is set
to logic 1 on the falling edge of AD0BUSY.
1: ADC0 conversion is in progress.
Write:
0: No Effect.
1: Initiates ADC0 Conversion if AD0CM1-0 = 00b
AD0WINT: ADC0 Window Compare Interrupt Flag.
This bit must be cleared by software.
0: ADC0 Window Comparison Data match has not occurred since this flag was last cleared.
1: ADC0 Window Comparison Data match has occurred.
AD0LJST: ADC0 Left Justify Select
0: Data in ADC0H:ADC0L registers is right justified.
1: Data in ADC0H:ADC0L registers is left justified. This option should not be used with a
repeat count greater than 1 (when AD0RPT1-0 is 01b, 10b, or 11b).
AD0CM1-0: ADC0 Start of Conversion Mode Select.
00: ADC0 conversion initiated on every write of ‘1’ to AD0BUSY.
01: ADC0 conversion initiated on overflow of Timer 3.
10: ADC0 conversion initiated on rising edge of external CNVSTR.
11: ADC0 conversion initiated on overflow of Timer 2.
R/W
Bit6
SFR Definition 5.5. ADC0CN: ADC0 Control
R/W
Bit5
R/W
Bit4
Rev. 1.1
R/W
Bit3
R/W
Bit2
R/W
Bit1
(bit addressable)
R/W
Bit0
SFR Address:
Reset Value
0xE8