DV164121 Microchip Technology, DV164121 Datasheet - Page 71

• Manufacturer Part Number: DV164121
• Description: KIT PICKIT 2 DEBUG EXPRESS
• Manufacturer: Microchip Technology
• Series: PICkit™ 2r
• Type: Microcontrollerr

Specifications of DV164121

• Contents: Board, PICkit™ 2 Programmer, Cable, CD
• Processor To Be Evaluated: PIC family
• Data Bus Width: 8 bit, 16 bit, 32 bit
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: PIC Micro® MCU
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

© 2008 Microchip Technology Inc.
The window may be resized by clicking and dragging on the lower right corner of the
window.
7.3.1
The baud rate may be selected from the combo box in the upper left corner of the UART
Tool window. Several common baud rates are listed, and by selecting “Custom…” any
baud rate from 150 to 38400 in 1 baud increments may be used (Figure 7-3).
FIGURE 7-3:
Once a custom baud rate has been set, it will be available as the last item in the baud
rate selection box (Figure 7-4). Only one custom baud rate may be set at a time. Select
“Custom…” again to change the custom baud rate.
FIGURE 7-4:
After selecting the baud rate, click Connect to enable the UART Tool serial interface at
the selected baud. Once the serial interface has been enabled, it may be disabled by
clicking Disconnect. The baud rate may only be changed while the interface is
disconnected.
7.3.2
When ASCII mode is selected, serial bytes received from the target’s UART are dis-
played as ASCII characters in the main window terminal display. All bytes are displayed
consecutively. To display a new line, the target UART must transmit the character val-
ues 0x0D (carriage return) and 0x0A (line feed) in sequence. If one of these values is
sent, or they are sent in reverse order, the character(s) will appear as an unprintable
character (box) in the display.
Bytes may be transmitted in three ways:
1. Click on the terminal display to select it. Any characters typed on the PC
2. Right click on the terminal display and select Paste from the pop-up menu to
3. Use the “String Macros” at the bottom of the window.
keyboard will be immediately transmitted out of PICkit 2.
paste any previous copied or cut text. <Ctrl> + <v> may also be used. Any pasted
data will immediately be transmitted out of PICkit 2.
Setting the Baud Rate and Connecting
ASCII Mode
BAUD RATE SELECTION
CUSTOM 14400 BAUD RATE
DS51553E-page 67