M34509T2-CPE Renesas Electronics America, M34509T2-CPE Datasheet - Page 69

• Manufacturer Part Number: M34509T2-CPE
• Description: DEV TOOL COMPACT EMULATOR: 4508/
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of M34509T2-CPE

• Contents: Compact Emulator, IDE, Assembler and Linker
• For Use With/related Products: 4508, 4509
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

M34509T2-CPE User’s Manual
5.2 When the Emulator Debugger Does Not Start Up Properly
(1) When the LEDs of the M34509T2-CPE Do Not Display Normally
Table 5.1 Errors LEDs show and their checkpoints 1
Table 5.2 Errors LEDs show and their checkpoints 2
(2) Init Dialog Box Does Not Appear at Debugger Startup
Table 5.3 Checkpoints of errors at debugger startup
REJ10J0543-0200 Rev.2.00 Sep. 25, 2006
System Status POWER LED does
not light up.
Communication error occurred.
Data was not sent to the target.
Not compact emulator.
POWER
Target Status LED display
CLOCK
Blinking
Others
Error
Error
RESET
OFF
RUN
the user system
the user system
Connection to
Connection to
- Check the target status LED display. If the LED is blinking, the emulator did not
- Check that the USB cable is connected properly.
- USB device driver has been installed before the emulator debugger start up?
Check that an emulator other than the compact emulator (such as PC4701, PC7501) is
not connected.
Disconnected
Connected
start up normally.
See “2.5.5 LED Display When the Emulator Starts Up Normally” (page 26).
See "2.4 Connecting the Host Machine " (page 23).
See “2.2.2 Installing the USB Device Driver” (page 21)
-
-
-
-
-
-
-
- The emulator may be damaged. Contact your local distributor.
Check that power (Vcc) is properly supplied to the user system and
that the user system is properly grounded.
The emulator system is working properly.
Target Status POWER LED does not light up when the user system
is disconnected
The emulator system is not working properly.
- Check that power is supplied to the emulator.
A clock is not supplied to the emulator.
- Check that the oscillator circuit board (OSC-2) is attached.
- Check that the oscillator on the oscillator circuit board (OSC-2) or
Refer to “2.8.2 Selecting Clock Supply” (page 34)
The MCU cannot be controlled.
- Check that the MCU is properly attached.
- Check that the oscillation frequency of the oscillator circuit board
The emulator system is not working properly.
- The emulator may be damaged. Contact your local distributor.
Check that the power cable is connected.
See “2.3 Connecting the Power Supply for the Emulator” (page 22).
the oscillation module is oscillating properly.
(OSC-2) is within the specified range.
Checkpoint
Problem & Remedy
Checkpoint
5. Troubleshooting
Page 67 of 72