HS38000EPI61H Renesas Electronics America, HS38000EPI61H Datasheet - Page 223

• Manufacturer Part Number: HS38000EPI61H
• Description: DEV EMULATOR BASE UNIT H8/38000
• Manufacturer: Renesas Electronics America
• Type: Microcontrollerr

Specifications of HS38000EPI61H

• Contents: E6000 Emulator and CD-ROM
• For Use With/related Products: 38000 Series
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

[General] page (cont)
The MCUs selectable by the [Device] option and options that depend on the MCUs are listed below. To emulate
an MCU with a description in the Expansion Hardware column, connect the correct expansion hardware.
Table 8.12 Environment for the H8/3827R E6000 Emulator CPU 300L Debugging Platform
Hardware
HS388REPI60H
Notes: 1. Target/2 in [Clock] and Target in [SubClock] are only available when the target system is connected.
Table 8.13 Environment for the H8/3847R E6000 Emulator CPU 300L Debugging Platform
Hardware
HS388REPI60H
Notes: 1. Target/2 in [Clock] and Target in [SubClock] are only available when the target system is connected.
202
[Break on access error]
[User VCC Threshold]
[User Signals]
[Driver]
[Change driver in start up]
2. To emulate an H8/3827S-group MCU, select an H8/3827R-group MCU as the [Device] option (e.g.
2. To emulate an H8/3847S-group MCU, select an H8/3847R-group MCU as the [Device] option (e.g.
H8/3827R for emulation of the H8/3827S).
H8/3847R for emulation of the H8/3847S).
[Device] Option
H8/3822R
H8/3823R
H8/3824R
H8/3825R
H8/3826R
H8/3827R
[Device] Option
H8/3842R
H8/3843R
H8/3844R
H8/3845R
H8/3846R
H8/3847R
When this box is checked, a break (the user program stops) occurs if
your program accesses an access-prohibited area or writes to a write-
protected area.
Sets the voltage level for the user system. [Down] will be displayed in
[User System Voltage] of the [Extended Monitor] window when the actual
user VCC of the target system is lower than the specified value.
When this box is checked, the reset and NMI signals from the user
system are enabled.
Displays the E6000 driver that is currently installed.
When this box is checked, selection of a driver will be available next time
the emulator is connected.
[Clock] Option
0.5 MHz
2 MHz
8 MHz
Target/2
[Clock] Option
0.5 MHz
2 MHz
8 MHz
Target/2
[SubClock] Option
38.4 kHz
307.2 kHz
32.768 kHz
Target
[SubClock] Option
38.4 kHz
307.2 kHz
32.768 kHz
Target
Expansion Hardware
None
Expansion Hardware
None