HS3664EPI62H Renesas Electronics America, HS3664EPI62H Datasheet - Page 206

• Manufacturer Part Number: HS3664EPI62H
• Description: EMULATOR BASE UNIT H8/3664
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of HS3664EPI62H

• Contents: E6000 Emulator and CD-ROM
• For Use With/related Products: H8/3664
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

[General] page (cont)
The MCUs selectable by the [Device] option and options that depend on the MCUs are listed below. To emulate
an MCU with a description in the Expansion Hardware column, connect the correct expansion hardware.
184
[Break on access error]
[Enable internal ROM area write]
[Transit to active mode at break]
[User VCC Threshold]
[User Signals]
[Driver]
[Change driver in start up]
When this box is checked, a break (the user program stops) occurs if
your program accesses an access-prohibited area or writes to a write-
protected area.
When this box is checked, writing to the internal ROM area is enabled.
For the result of writing, see the [Extended Monitor] window.
Checking this box causes the emulator to enter the active mode when a
break occurs if the emulator has been in the subactive mode immediately
before the occurrence of a break. This allows a break processing by the
system clock.
Sets the voltage level for the user system. [Down] will be displayed in
[User System Voltage] of the [Extended Monitor] window when the actual
user VCC of the target system is lower than the specified value.
When this box is checked, the reset and NMI signals from the user
system are enabled.
Displays the E6000 driver that is currently installed.
When this box is checked, selection of a driver will be available next time
the emulator is connected.