ATF15XX-SAQ100 Atmel, ATF15XX-SAQ100 Datasheet - Page 33

• Manufacturer Part Number: ATF15XX-SAQ100
• Description: ADAPTER FOR ATF15XX-DK2 100PQFP
• Manufacturer: Atmel

Specifications of ATF15XX-SAQ100

• Accessory Type: ATF15xxDK2 Adapter
• For Use With/related Products: 160-PQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

CPLD Development/Programmer Kit User Guide
6. The next step is to specify the JEDEC file to be programmed into the target
The next few steps require the user to setup the Atmel CPLD Development/Programmer
Board to program the ATF1508AS through ISP.
7. Connect the 25-DB side of the Atmel-ISP Cable to the PC's parallel port and the
8. Connect a 9V AC/DC power adapter to the power connector (JPower) of the
9. Set the 5V/3.3V jumper to 5V. This will set the system board V
10. Set the JPCLK jumper to GCLK1 so that the output of the crystal oscillator will
11. Connect the 84-pin PLCC Socket Adapter Board onto the main Develop-
Note:
12. Switch the Power Switch to the ON position.
13. Select the appropriate LPT port in the Port Setting field. LPT 1 is the default port.
14. Select the ISP download cable type in the Cable Types field. The default cable
Now both the user’s software and hardware are setup for ISP programming, and the
user can execute the PROGRAM/VERIFY instruction to program the ATF1508AS on
the Atmel CPLD Development/Programmer Board.
device in the JEDEC File field. Click on the Browse button, change the directory
to [..\PROCHIP\DESIGNS\CUPL"] and then select LOGIC_D8.JED as the tar-
get JEDEC file. Click OK to close the JTAG Device Properties window when all
properties are specified.
10-pin header side of the Atmel-ISP Cable to the Atmel CPLD Development
Board as shown Figure 2-5.
Atmel CPLD Development/Programmer Board.
be connected to Pin 83 of the ATF1508AS.
ment/Programmer Board.
type is the Atmel ISP Cable but it can be changed to the Altera ByteBlaster cable
if the ByteBlaster cable is being used.
If a device in a different package type is to be programmed, then the appropriate Socket
Adapter Board must be used.
Device Type
(4) Specify
(5) Specify
Instruction
(6) Select
Target
JEDEC
JTAG
File
CPLD Design Flow Tutorial
CC
to 5V.
3300A–PLD–08/02
3-13