PMF18WD1 Microchip Technology, PMF18WD1 Datasheet - Page 73
![PROCESSOR MODULE FOR ICE4000](/photos/26/90/269011/processormodule-ice4000_general_sml.jpg)
PMF18WD1
Manufacturer Part Number
PMF18WD1
Description
PROCESSOR MODULE FOR ICE4000
Manufacturer
Microchip Technology
Datasheet
1.ICE4000.pdf
(98 pages)
Specifications of PMF18WD1
Module/board Type
Processor Module
Product
Microcontroller Modules
Core Processor
PIC18F1310 and PIC18F1320
Lead Free Status / RoHS Status
Contains lead / RoHS non-compliant
For Use With/related Products
ICE4000
For Use With
ICE4000 - EMULATOR MPLAB-ICE 4000 POD
Lead Free Status / RoHS Status
Lead free / RoHS Compliant, Contains lead / RoHS non-compliant
8.18
2004 Microchip Technology Inc.
SETTINGS DIALOG, PINS/PINS AND USAGE TAB
Set up the operation of special pins for your selected device. Other options may be
available, depending on device selected.
8.18.1
TABLE 8-13:
8.18.2
TABLE 8-14:
User Master Clear and Master Clear Pull-up
MCLR Pin Usage
MCLR Pull-up Resistor
Supplied by ICE
Enable MCLR Low
Warning (if pull-up
supplied by ICE
Emulator Operation
Preserve user's external
bus access method when
halted
Pins
MCLR Pull-up Resistor
Connected
Emulator Operation and Usage
Enable Clip-on Emulation
on Target Board Device
PIC18X Devices Only
dsPIC Devices Only
PINS AND USAGE TAB PIC18X DEVICES ONLY
PINS AND USAGE TAB
Display how the MCLR pin will be used, either as master clear or
an input port pin.
Connect/disconnect the resistor on the MPLAB ICE 4000 header
used to pull up the MCLR pin.
Warning: Disconnecting may lock up the emulator hardware.
Display a Warning message if MCLR voltage level is low. This
would indicate a problem, as the pull-up should be keeping the
level high.
The purpose of this check box is to keep the emulator from
changing external bus access methods during the “halted” state of
the emulator when using Extended Microcontroller mode.
Generally, the emulator would change external bus access
methods to the most efficient method for the emulator during Halt.
However, this process tri-states the external bus, causing the bus
and control lines to float. This may cause problems for the target
system.
By selecting “Preserve user's external bus access method when
halted”, the bus stays active during “halted” states. This may cause
the emulator's response to be slightly slower and there will be bus
activity generated by the emulator system.
Connect/disconnect the resistor on the MPLAB ICE 4000 header
used to pull up the MCLR pin.
Warning: Disconnecting may lock up the emulator hardware.
This feature not yet implemented.
For target dsPIC device in proper mode, emulate using target
device.
Emulator Function Summary
dsPIC DEVICES ONLY
DS51490A-page 67