INDART-ONE/FSL SofTec Microsystems SRL, INDART-ONE/FSL Datasheet - Page 23

• Manufacturer Part Number: INDART-ONE/FSL
• Description: PROG/DEBUG FOR HC08/HCS08/HCS12
• Manufacturer: SofTec Microsystems SRL
• Series: inDARTr
• Type: In-Circuit, Real-Time Debugger/Programmerr

Specifications of INDART-ONE/FSL

• Contents: In-circuit debugger/programmer unit, Cables, Evaluation Board and Software
• For Use With/related Products: Freescale HC08/S08/RS08/S12/S12X
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 520-1038; INDART-ONE

Each of the MON08 connector lines must be connected to the appropriate
pins of the specific target microcontroller used. Once a target microcontroller
has been selected, the “Communication Settings” dialog box (available in
CodeWarrior, DataBlaze and MultiBlaze) automatically shows you how to
connect that specific device to the MON08 connector.
1.4.3 BDM Connector
inDART-One uses the standard, 6-pin BDM connector defined by Freescale
to program and debug HCS08, RS08, S12 and S12X devices. You must
therefore provide such connector (see the diagram below) on your target
board.
Pin
1
2
3
4
5
6
7, 9, 11,
13, 15
8, 10, 12,
14, 16
Signal Name
RST_OUT#
GND
RST_IN#
RST#
TGT_IRQ#
IRQ#
TGT_MON4 ...
TGT_MON8
MON4 ... MON8
Table 1.3: MON08 Connector Signals (Enhanced Mode)
Description
Reset signal to target system: GND or open drain output
reflecting the state of the MCU RST# and RST_IN#
signals.
System ground.
Reset signal from target system: GND to V
control the state of the MCU RST# and RST_OUT#
signals.
MCU reset; held at V
microcontroller) out of reset. No other target-system logic
should be tied to this signal.
Interrupt signal from target system: GND to V
control the state of the MCU IRQ# signal.
MCU interrupt; held at V
not asserted.
I/O pins connected to target application.
I/O pins connected to target microcontroller.
TST
TST
(or V
inDART-One User's Manual
when the TGT_IRQ# signal is
DD
, depending on the target
DD
DD
input to
input to
21
1