STEVAL-IFS001V1 STMicroelectronics, STEVAL-IFS001V1 Datasheet - Page 6

• Manufacturer Part Number: STEVAL-IFS001V1
• Description: EVAL BOARD 3AXIS MEMS ACCELLRMTR
• Manufacturer: STMicroelectronics
• Series: MEMSr

Specifications of STEVAL-IFS001V1

• Design Resources: STEVAL-IFS001V1 Gerber Files STEVAL-IFS001V1 Schematic STEVAL-IFS001V1 Bill of Material
• Sensor Type: Accelerometer, 3 Axis
• Sensing Range: ±2g, 6g
• Interface: I²C, SPI
• Sensitivity: 1024 LSb/g
• Voltage - Supply: 2.16 V ~ 3.6 V
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: LIS3LV02DQ
• Processor To Be Evaluated: LIS3LV02DQ
• Interface Type: USB
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 497-5069

General description
6/14
The power supply for the camera is derived from 3.3 V supplied by the STR9 platform. A
double Shottky diode (D1) is used to reduce 3.3 V to 2.8 V. If R4 is not assembled, only one
of the two diodes is used and the output voltage is 2.76 V. If R4 is assembled, both of the
diodes are used in parallel and the output voltage is 2.84 V.
Figure 4.
When an application using more than one camera is used, the evaluation kits must have
different addresses in order to distinguish between the packets from each. Connector CN4
allows this function to be achieved (see
20000 is assigned as the default value.
Ethernet UDP port setting on CN4
Port 20000
1
2
Port 20001
Figure
1
2
4). If no jumper is used, the port address
Port 20002
1
2
Port 20003
AI14527
1
2
UM0469