PSDPRO-110 STMicroelectronics, PSDPRO-110 Datasheet - Page 3

• Manufacturer Part Number: PSDPRO-110
• Description: PROGRAMMER PSDPRO 110V PWR SUPP
• Manufacturer: STMicroelectronics
• Series: PSDPROr
• Type: Parallelr

Specifications of PSDPRO-110

• Contents: Programmer, Parallel Cable, Power Supply Adapter and ST Family Module
• For Use With/related Products: UPSD3200 Family
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

SUMMARY DESCRIPTION
The PSDpro is a high performance engineering
programmer designed to program ST's entire fam-
ily of PSD products. Through the use of inter-
changeable
configured to program any of ST’s OTP or Flash-
based PSD Products. It is controlled using ST's
PSDsoft Express software operating in the IBM-
PC compatible Windows 95/98/2000 or NT/XP en-
vironment. The PSDpro enables quick program-
SYSTEM REQUIREMENTS
Software
Must be used with PSDsoft Express software (ver-
sion 5.02 ES or later)
Hardware
INSTALLATION INSTRUCTIONS
1. Connect the parallel cable to the PC and the
2. Make sure the ST Family module and the
3. Connect the power supply.
4. Go to the main screen of PSDsoft Express and
5. Under the "Options" menu select "Hardware
PC Compatible Windows 95/98/2000 or NT/
XP
32MB of RAM
Hard-Disk space: approximately 30MB
CD-ROM Drive
PSDpro Programmer.
Socket Adaptor are firmly seated.
click on the "STMicroelectronics Conventional
Programmers" block or Select
"STMicroelectronics Conventional
Programmers" from the PSDsoft menu.
Setup."
Configure for PSDpro and choose "Auto
Select" or "Manual Select" for the parallel port:
–
–
Auto Select = PSDsoft selects the port
Manual Select = User selects the port
sockets,
the
PSDpro
can
be
PSDPRO - PARALLEL PORT PROGRAMMER
ming, greatly accelerating the system design
process.
The PSDpro is easy to use. The parallel port inter-
face to the host computer eliminates problems
with bus addresses, interrupt assignments, or soft-
ware installation. PSDpro is powered by an exter-
nal DC power supply
Parts List:
6. Select OK.
7. If there are no error messages, then the setup
8. If an error message appears, check all
Parallel cable
Power supply adapter (110V or 220V)
ST Family Module
–
PSDpro Programmer
and auto check procedure is completed.
connections and retry by repeating the
installation procedure or by merely selecting
the "H Test" (Hardware Test) icon on the main
screen.
Note: Repeat this procedure until there is no
longer an error message. If you cannot resolve
the conflict, contact ST technical support for
assistance via Internet Mail at
[e-mail].
The programming instructions are included in
the PSDsoft Express User Manual
downloadable from the ST website,
www.st.com/psm. Please refer to this
manual for programming assistance.
small edge connector PC board installed
atop the programmer prior to shipment
3/6