M5307C3 Freescale Semiconductor, M5307C3 Datasheet - Page 79

• Manufacturer Part Number: M5307C3
• Description: KIT EVALUATION FOR MCF5307
• Manufacturer: Freescale Semiconductor
• Series: ColdFire®r
• Type: Microprocessorr

Specifications of M5307C3

• Contents: Module Board, Installation Guide, Power Supply, Cable, Software and more
• Processor To Be Evaluated: MCF5307
• Interface Type: Ethernet
• For Use With/related Products: MCF5307
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

the Serial Presence Detect (SPD) functionality of the SDRAM to determine what
SDRAM
appropriately.
Please refer to the SDRAM Application Note in Appendix E for address muxing
3.3
There are two 512Kbyte Flash ROM on the M5307C3, U20 (high, even byte) and
U21 (low, odd byte).
The board is shipped with two 29LV004, 512K-byte, FLASH ROM for a total of
bytes. The first 128K of the Flash contains ROM Monitor firmware.
896K is available to the user.
(-CS0) enables both chips.
The MCF5307 chip-select logic can be programmed to generate the -TA for -CS0
signal after a certain number
parameter to three wait-states.
3.3.1. JP1 Jumper and User’s Program
This jumper
overwrite the ROM Monitor.
When the jumper is set between
the jumper is set between
of Flash (0x80000).
Procedure:
1. Compile and link as though the code was to be place at the base of the
2. Set up the jumper for Normal operation, pin1 connected to pin 2.
3. Download to SDRAM (If using serial or ethernet, start ROM Monitor first. If
4. In ROM Monitor, run 'upuser' command.
flash, but setup so that it will download to the SDRAM
0x80000.
depend upon the compiler used (using Diab Data, a "LOAD" command
linker file is used).
using BDM via wiggler, download first, then start ROM Monitor by pointing
PC to 0xffe00400 and run.)
FLASH
is populated in the evaluation board and configures the system
ROM
allows users to test code from the boot without having to
The user shoul to refer to the compiler for this, since it will
Freescale Semiconductor, Inc.
For More Information On This Product,
pins 2 and 3, the board boots from the second half
Go to: www.freescale.com
of wait states.
pins 1 and 2, the behavior is normal. When
The chip-select signal generated by
55
The dBUG
starting at address
programs
the MCF5307
The last
in the
this
1M