M3062PT-EPB Renesas Electronics America, M3062PT-EPB Datasheet - Page 75

• Manufacturer Part Number: M3062PT-EPB
• Description: EMUL PERSONALITY KIT M16C/62P
• Manufacturer: Renesas Electronics America

Specifications of M3062PT-EPB

• Accessory Type: Probe Accessory Kit
• For Use With/related Products: PC7501, M16C/62
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

(3) MCU Setting Dialog Box Does Not Appear at Debugger Startup (target not connected)
Table 6.3 Checkpoints of errors at debugger startup (target not connected)
(4) Errors Occur at Debugger Startup (target connected)
Table 6.4 Checkpoints of errors at debugger startup (target connected)
Communication error occurred.
Data was not sent to the target.
Target system cannot be properly built.
M3T-PD30F version is not the same version
as the firmware in the target.
Target is in HOLD state.
Target MCU is uncontrollable.
Error
Error
( 73 / 80 )
Check that all emulator debugger settings, interface
cable settings and switches on the rear of the PC7501
match.
See the user's manuals of the PC7501 and emulator
debugger.
(1) Download the proper firmware.
(2) Recheck that the connection between the PC7501
Download the proper firmware.
See "4.2 Downloading Firmware" (page 48).
(1) If in memory expansion mode or microprocessor
(2) The MCU is either in stop mode or wait mode. Either
(1) Check that pin NMI* is held High.
(2) If in Memory expansion mode or microprocessor
See "4.2 Downloading Firmware" (page 48).
and this product.
See "3.5 Connecting the PC7501" (page 33).
mode, check pins RDY* and HOLD* are held High.
reset the MCU or cancel the mode with an interrupt.
See MCU specifications.
mode, check that pins RDY* and HOLD* are held
High.
Checkpoint
Checkpoint