HS7751RKCI02H Renesas Electronics America, HS7751RKCI02H Datasheet - Page 40

• Manufacturer Part Number: HS7751RKCI02H
• Description: ON CHIP DEBUG EMULATOR W/TRACE
• Manufacturer: Renesas Electronics America

Specifications of HS7751RKCI02H

• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

2.4 Connecting the Card Emulator to the User System
(1) The Hitachi-UDI port connector must be installed to the user system. Table 2.1 shows the
Table 2.1 Recommended Hitachi-UDI Port Connector
Connector
14-pin connector
36-pin connector
Note: When the 14-pin connector is used, do not install any components within 3 mm of the
(2) Note that the TDO signal of the user system interface cable connector must be connected to
(3) Figure 2.4 shows how to connect the user system interface cable to the user system when the
12
Failure to do so will damage the host computer.
1. Turn off the host computer.
2. Insert the emulator into the PCI slot in parallel.
3. Screw in the emulator after checking the connector and
recommended Hitachi-UDI port connector for the emulator.
the TDI pin of the Hitachi-UDI port connector and the TDI signal of the user system interface
cable connector must be connected to the TDO pin of the Hitachi-UDI port connector. Section
6.2 shows the pin arrangement of the Hitachi-UDI port connector.
14-pin straight type connector is used. Connect the ground line of the cable to the user system
ground. The end of the ground line has a hole having a diameter of 3 mm, and therefore,
when the ground line is screwed to the user system, the screw diameter must be 3 mm.
cable positions.
Hitachi-UDI port connector.
When the 36-pin connector is used, do not connect other signal lines to the Hitachi-
UDI port connector.
When inserting the PCI-card emulator, note the following.
Type Number
2514-6002
DX10M-36S
DX10M-36SE,
DX10GM-36SE
WARNING
Manufacturer
Minnesota Mining &
Manufacturing Ltd.
Hirose Electric Co., Ltd.
Specifications
14-pin straight type
Lock-pin type
Screw type