866 B&K Precision, 866 Datasheet - Page 139

• Manufacturer Part Number: 866
• Description: PROGRAMMER UNIV W/ USB INTERFACE
• Manufacturer: B&K Precision
• Type: Universalr

Specifications of 866

• Contents: Programmer, Adapter, Cable, Manual and Software
• For Use With/related Products: EPROM, EEPROM-Flash, Serial EPROM, Microcontroller & PLD
• Other names: 866BK; Q2005647

Programmer / Module options
Programmer / Automatic YES!
Handler is not available for sale.
This command is used for setting Automatic YES! mode. In
this mode you just put a device into ZIF socket and a last
operation
automatically detects an insertion of a new device and runs
last executed operation without pressing any key or button. An
insertion of device into ZIF is displayed on the screen.
Repeated operation executing will be cancelled by pressing
key <ESC> during waiting for insert/remove a device to/from
ZIF.
After an operation with a device is executed, one of the OK or
ERROR (status) LEDs on the programmer will lights in
dependence on the result of an operation and the BUSY LED
will blinking.
If the program detects removal of a device, then status LED
will switched off, but the BUSY LED will still blinking to indicate
readiness of the program to repeat last operation with new
device.
After the program indicates one or more pins of (new) device in
the ZIF socket of the programmer, the BUSY LED will goes to
light continually. From this the program will wait a requested
time for insert the rest pins of new device. If a requested time
(Device insertion complete time) overflows and a device is not
correctly inserted, the program will light the ERROR LED to
indicate this state. After new device was inserted correctly, the
program will switch off all status LEDs, except BUSY, and will
start an operation with new device.
This mode may be enabled or disabled by item Automatic
YES! mode. If a new programmer is selected Options / Find
programmer, this mode will be disabled.
In Response time is possible to set a time interval within must
being detected device in ZIF socket to accept an insertion of a
new device. Default is set standard interval. If socket adapter
is used then is recommended to set an elongated interval.
This option is used for multiple socket programmers for
defining MASTER socket and activity of each socket.
MASTER socket group box allows user to set socket which is
preferentially
Enable/Disable socket checkbox array allows user to set
enabling and disabling of each socket individually. Disabled
sockets are ignored for any device operation.
will
used
be
repeated
for
139
device
automatically.
reading
operation.
Program