EPSILON5-UPG3 Equinox Technologies, EPSILON5-UPG3 Datasheet - Page 26

• Manufacturer Part Number: EPSILON5-UPG3
• Description: UPGRADE EPSILON5 JTAG ISP AVRMCU
• Manufacturer: Equinox Technologies
• Type: Upgrade Kitr

Specifications of EPSILON5-UPG3

• Mfg Application Notes: SPI and JTAG (ISP), Appl Note
• For Use With/related Products: Epsilon5
• Other names: 483-1008

Key:
S – Device supported as standard
U – Chargeable license upgrade required
* – Device support not available at the time of this document going to press. Please contact Equinox
for a device support update.
1.6.2 Programming Interface to Target Device
The programmer supports the following programming interfaces to the Target Device:
#
1
2
3
4
Please refer to section 4 for information on which ISP Header to use for the required programming
interface.
EPSILON5 MKII Programmer - User Guide V1.12 – 1
Programming
Interface
LV SPI
HV SPI (+12V
Vpp)
UART Boot
Loader
JTAG
(Atmel AVR)
Family
AT89S
AT90S
AT90USB
AT90CAN
ATmega
ATtiny
Zensys
ATtiny
T89C51Rx2
P89X51Rx2
ATmega
AT90USB
AT90CAN
Description / Comment
Atmel Low Voltage Serial Programming Mode
Atmel High Voltage Serial Programming Mode
Atmel / Philips UART Boot Loader Interface
Atmel ATmega AVR – JTAG ISP Interface
•
•
•
•
•
•
•
•
•
•
•
Atmel 3-wire SPI interface (SCK, MOSI, MISO )
Target Device RESET
Works at target voltage (no Vpp required)
Atmel 4-wire SPI Interface (SCK, MOSI, MISO, MOSI2)
+12V Vpp is applied to the RESET pin to enter High
Voltage Serial Programming Mode
Requires different connections to Target Device
compared with LV SPI.
Requires all pins of target device to be accessible by the
programmer.
Uses RXD, TXD, PSEN, and Target Device RESET pin
TTL Levels from programmer to Target System
Uses same connector as Atmel JTAG ICE
A chargeable license upgrade is required to enable the
ATmega JTAG ISP libraries.
st
August 2007
15