K-HSTTA Panduit Corp, K-HSTTA Datasheet - Page 51

• Manufacturer Part Number: K-HSTTA
• Description: KIT HT SHRINK ADH 3/16"-1" BLK
• Manufacturer: Panduit Corp

Samples of material, with dimension 5" by 1/2" and the thickness of the intended end use product, are tested
in a unaged “as manufactured” state and in an aged state (7 days at 158F° ,70°C). The test requires the
placement of a precisely controlled flame under a vertically supported specimen for a 10 second period.
The flame is removed and the duration of flaming is recorded. If the flame extinguishes, the specimen is
immediately subjected to a second 10 second ignition period. Duration of flaming is again recorded. A piece
of surgical cotton is placed under the specimen. If drips ignite the cotton, this fact is also recorded.
Abrasion Protection Products Flammability Tests and Classifications
Materials classified 94V-0 shall:
• Not have any specimens which burn with flaming combustion for more than 10 seconds after either
• Not have a total flaming combustion time exceeding 50 seconds for the 10 flame applications for each set
• Not have any specimens which burn with flaming or glowing combustion up to the holding clamp.
• Not have any specimens which drip flaming particles that ignite the dr y absorbent surgical cotton located
• Not have any specimens with glowing combustion which persists for more than 30 seconds after the
(Cont. on
application of the test flame.
of five specimens.
12" (305mm) below the test specimen.
second removal of the test flame.
page
52)
MATERIALS CLASSIFIED 94V-0
UL94 Vertical Burning Test
• A number of test procedures have been developed
• Review the following classifications to find which
which can be used for the evaluation and comparison
of various materials to suppor t combustion.
category is designed to suit your abrasion and
protection applications.
Flammability Tests and Classifications
51