R5F21217JFP#U1 Renesas Electronics America, R5F21217JFP#U1 Datasheet - Page 448

• Manufacturer Part Number: R5F21217JFP#U1
• Description: MCU FLASH 48K 2.5K CMOS 48LQFP
• Manufacturer: Renesas Electronics America
• Series: R8C/2x/21r

Specifications of R5F21217JFP#U1

• Core Processor: R8C
• Core Size: 16/32-Bit
• Speed: 20MHz
• Connectivity: I²C, LIN, SIO, SSU, UART/USART
• Peripherals: POR, Voltage Detect, WDT
• Number Of I /o: 41
• Program Memory Size: 48KB (48K x 8)
• Program Memory Type: FLASH
• Ram Size: 2.5K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 5.5 V
• Data Converters: A/D 12x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 48-LQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

R8C/20 Group, R8C/21 Group
Rev.2.00 Aug 27, 2008
REJ09B0250-0200
Figure 21.1
21.2.4
The IR bit in the interrupt control register may be set to 1 (interrupt requested) when the interrupt source
changes. When using an interrupt, set the IR bit to 0 (no interrupt requested) after changing the interrupt source.
In addition, the changes of interrupt sources include all sources that change the interrupt sources assigned to
individual software interrupt numbers, polarities, and timing. Therefore, when a mode change of the peripheral
functions involves interrupt sources, edge polarities, and timing, Set the IR bit to 0 (no interrupt requested) after
the change. Refer to each peripheral function for the interrupts caused by the peripheral functions.
Figure 21.1 shows an Example of Procedure for Changing Interrupt Sources.
Changing Interrupt Sources
Example of Procedure for Changing Interrupt Sources
NOTES:
IR bit:
1. Execute the above settings individually. Do not execute two
2. To prevent interrupt requests from being generated, disable
3. Refer to 12.6.5 Changing Interrupt Control Register
Page 430 of 458
or more settings at once (by one instruction).
the peripheral function before changing the interrupt
source. In this case, use the I flag if all maskable interrupts
can be disabled. If all maskable interrupts cannot be
disabled, use bits ILVL0 to ILVL2 of the interrupt whose
source is changed.
Contents for the instructions to be used and usage notes.
The interrupt control register bit of an
interrupt whose source is changed.
Set the IR bit to 0 (interrupt not requested)
Change interrupt source (including mode
using the MOV instruction
Interrupt source change
of peripheral function)
Disable interrupts
Enable interrupts
Change completed
(2, 3)
(2, 3)
(3)
21. Usage Notes