HD6473258P10V Renesas Electronics America, HD6473258P10V Datasheet - Page 183

• Manufacturer Part Number: HD6473258P10V
• Description: MCU 5V 32K PB-FREE 64-DIP
• Manufacturer: Renesas Electronics America
• Series: H8® H8/325r

Specifications of HD6473258P10V

• Core Size: 8-Bit
• Program Memory Size: 32KB (32K x 8)
• Oscillator Type: External
• Core Processor: H8/300
• Speed: 10MHz
• Connectivity: SCI, UART/USART
• Number Of I /o: 53
• Program Memory Type: OTP
• Ram Size: 1K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 64-DIP
• No. Of I/o's: 53
• Ram Memory Size: 1024Byte
• Cpu Speed: 10MHz
• No. Of Timers: 3
• Digital Ic Case Style: DIP
• Supply Voltage: RoHS Compliant
• Controller Family/series: H8/330
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Data Converters: -
• Peripherals: -
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Bit 4 – Receive Enable (RE): This bit enables or disables the receive function. When the receive
function is enabled, the RxD pin is automatically used for input. When the receive function is
disabled, the RxD pin is available as a general-purpose I/O port.
Bit 4
RE
Bits 3 and 2 – Reserved: These bits cannot be modified and are always read as 1.
Bit 1 – Clock Enable 1 (CKE1): This bit selects the internal or external clock source for the baud
rate generator. When the external clock source is selected, the SCK pin is automatically used for
input of the external clock signal.
Bit 1
CKE1
Bit 0 – Clock Enable 0 (CKE0): When an internal clock source is used in asynchronous mode,
this bit enables or disables serial clock output at the SCK pin.
This bit is ignored when the external clock is selected, or when the synchronous mode is selected.
Bit 0
CKE0
For further information on clock source selection, see table 9-6 in Section 9.3, Operation.
0
1
0
1
0
1
Description
The receive function is disabled. The RxD pin can be
used for general-purpose I/O.
The receive function is enabled.
The RxD pin is used for input.
Description
Internal clock source.
When C/A = 1, the clock is output at SCK.
When C/A = 0, clock output depends on CKE0.
External clock source, input at SCK.
Description
The SCK pin is not used by the SCI (and is available as
a general-purpose I/O port).
The SCK pin is used for serial clock output.
176
(Initial value)
(Initial value)
(Initial value)